[PATCH] tpm_tis_spi: fix:release chip select when flow control fails

[Peijie Shao]

From: Peijie Shao <shaopeijie@xxxxxxxxx>

The TPM's chip select will leave active after spi_bus_unlock when
flow control timeout, and may interfere other chips sharing the same
spi bus, or may damage them dule to level conflict on MISO pin.

So the patch deactives the chip select by sending an empty message
with cs_change=0 if flow control fails.

The reason why flow control timeout for me is unfortunately I got a
damaged TPM chip. It always pull MISO low during cs active(this can
be easily emulated by wire MISO to the ground), not responding anything,
and dmesg shows below:
...
[   311.150725] tpm_tis_spi: probe of spi0.0 failed with error -110
...

Signed-off-by: Peijie Shao <shaopeijie@xxxxxxxx>
---
drivers/char/tpm/tpm_tis_spi_main.c | 13 ++++++++++++-
1 file changed, 12 insertions(+), 1 deletion(-)

diff --git a/drivers/char/tpm/tpm_tis_spi_main.c
b/drivers/char/tpm/tpm_tis_spi_main.c
index a0963a3e92bd..5c8ff343761f 100644
--- a/drivers/char/tpm/tpm_tis_spi_main.c
+++ b/drivers/char/tpm/tpm_tis_spi_main.c
@@ -105,8 +105,19 @@ int tpm_tis_spi_transfer(struct tpm_tis_data
*data, u32 addr, u16 len,
/* Flow control transfers are receive only */
spi_xfer.tx_buf = NULL;
ret = phy->flow_control(phy, &spi_xfer);
- if (ret < 0)
+ if (ret < 0) {
+ /*
+ * Release cs pin if the device is not responding, regardless of the reason.
+ * Notice cs may alreadly been released if the failure was caused inside
+ * spi_sync_locked called by flow_control, in this situation, a pluse may be
+ * generated on cs.
+ */
+ memset(&spi_xfer, 0, sizeof(spi_xfer));
+ spi_message_init(&m);
+ spi_message_add_tail(&spi_xfer, &m);
+ spi_sync_locked(phy->spi_device, &m);
goto exit;
+ }
spi_xfer.cs_change = 0;
spi_xfer.len = transfer_len;
--
2.39.1