Aw: Re: Re: Re: Re: Re: [PATCH v3 0/5] arm: dts: mt7623: relocate gmacs, mt7530 switch, and add port@5

[Frank Wunderlich]

Hi

> Gesendet: Mittwoch, 12. April 2023 um 18:21 Uhr
> Von: "Arınç ÜNAL" <arinc.unal@xxxxxxxxxx>
> > thanks, it changes the master when i upgrade iproute to 6.1 (from debian bullseye-backports), but i cannot do any traffic on it after switching to gmac1...
> > 
> > 5: wan@eth1: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue state UP group default qlen 1000
> >      link/ether f2:d2:51:56:cd:3d brd ff:ff:ff:ff:ff:ff
> >      inet 192.168.0.11/24 scope global wan
> >         valid_lft forever preferred_lft forever
> > 
> > see no p5-TX/gmac-rx

> Did you apply the vlan and flooding fix patches from Richard?

have now applied all patches i've found from richard (which are all rejected):

fe4495bb3cc2 2023-02-12 Fix setting up CPU and User ports to be in the correct mode during setup and when toggling vlan_filtering on a bridge port.  (HEAD -> 6.3-rc)
b0641f3e1a69 2023-02-12 Fix Flooding: Disable by default on User ports and Enable on CPU ports 
cb04b3451524 2023-02-12 Do not add all User ports to the CPU by default. This will break Multi CPU when added a seperate patch. It will be overwritten by .port_enable and since we are forcing output to a port via the Special Tag this is not needed.

and now it seems working and is clear ;)

root@bpi-r2:~# ip l show wan
5: wan@eth1: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue state UP mode DEFAULT group default qlen 1000
    link/ether f2:d2:51:56:cd:3d brd ff:ff:ff:ff:ff:ff

iperf3
[ ID] Interval           Transfer     Bitrate         Retr                                                                                                                    
[  5]   0.00-10.00  sec  1.09 GBytes   940 Mbits/sec    0             sender                                                                                                  
[  5]   0.00-10.03  sec  1.09 GBytes   936 Mbits/sec                  receiver                                                                                                


iperf3 -R
[ ID] Interval           Transfer     Bitrate         Retr                                                                                                                    
[  5]   0.00-10.04  sec  1.09 GBytes   936 Mbits/sec    0             sender                                                                                                  
[  5]   0.00-10.00  sec  1.09 GBytes   938 Mbits/sec                  receiver                                                                                                


how do you deal with these patches? do you include them into your mt7530 fixes series? they (and vladimirs preferred cpu-port) need to be applied before these DTS-changes

regards Frank