[RFC PATCH net-next 07/22] net: dsa: mt7530: do not run mt7530_setup_port5() if port 5 is disabled

From: arinc9 . unal
Date: Fri Apr 21 2023 - 10:37:41 EST


From: Arınç ÜNAL <arinc.unal@xxxxxxxxxx>

There's no need to run all the code on mt7530_setup_port5() if port 5 is
disabled. The only case for calling mt7530_setup_port5() from
mt7530_setup() is when PHY muxing is enabled. That is because port 5 is not
defined as a port on the devicetree, therefore, it cannot be controlled by
phylink.

Because of this, run mt7530_setup_port5() if priv->p5_intf_sel is
P5_INTF_SEL_PHY_P0 or P5_INTF_SEL_PHY_P4. Remove the P5_DISABLED case from
mt7530_setup_port5().

Stop initialising the interface variable as the remaining cases will always
call mt7530_setup_port5() with it initialised.

Tested-by: Arınç ÜNAL <arinc.unal@xxxxxxxxxx>
Signed-off-by: Arınç ÜNAL <arinc.unal@xxxxxxxxxx>
---
drivers/net/dsa/mt7530.c | 9 +++------
1 file changed, 3 insertions(+), 6 deletions(-)

diff --git a/drivers/net/dsa/mt7530.c b/drivers/net/dsa/mt7530.c
index 591df09c8bb5..bac2388319a3 100644
--- a/drivers/net/dsa/mt7530.c
+++ b/drivers/net/dsa/mt7530.c
@@ -932,9 +932,6 @@ static void mt7530_setup_port5(struct dsa_switch *ds, phy_interface_t interface)
/* MT7530_P5_MODE_GMAC: P5 -> External phy or 2nd GMAC */
val &= ~MHWTRAP_P5_DIS;
break;
- case P5_DISABLED:
- interface = PHY_INTERFACE_MODE_NA;
- break;
default:
dev_err(ds->dev, "Unsupported p5_intf_sel %d\n",
priv->p5_intf_sel);
@@ -2282,8 +2279,6 @@ mt7530_setup(struct dsa_switch *ds)
* Set priv->p5_intf_sel to the appropriate value if PHY muxing
* is detected.
*/
- interface = PHY_INTERFACE_MODE_NA;
-
for_each_child_of_node(dn, mac_np) {
if (!of_device_is_compatible(mac_np,
"mediatek,eth-mac"))
@@ -2315,7 +2310,9 @@ mt7530_setup(struct dsa_switch *ds)
break;
}

- mt7530_setup_port5(ds, interface);
+ if (priv->p5_intf_sel == P5_INTF_SEL_PHY_P0 ||
+ priv->p5_intf_sel == P5_INTF_SEL_PHY_P4)
+ mt7530_setup_port5(ds, interface);
}

#ifdef CONFIG_GPIOLIB
--
2.37.2