Re: [PATCH 2/5] arm64: dts: qcom: qrb4210-rb2: Enable display out

[Konrad Dybcio]

On 15.05.2023 17:57, Caleb Connolly wrote:
> 
> 
> On 15/05/2023 13:04, Konrad Dybcio wrote:
>> The RB2 has a HDMI output via an LT9611UXC bridge. Set it up.
>>
>> Signed-off-by: Konrad Dybcio <konrad.dybcio@xxxxxxxxxx>
>> ---
>>  arch/arm64/boot/dts/qcom/qrb4210-rb2.dts | 88 +++++++++++++++++++++++++++++++-
>>  1 file changed, 87 insertions(+), 1 deletion(-)
>>
>> diff --git a/arch/arm64/boot/dts/qcom/qrb4210-rb2.dts b/arch/arm64/boot/dts/qcom/qrb4210-rb2.dts
>> index 80c6b59c8ff6..9b539720f05d 100644
>> --- a/arch/arm64/boot/dts/qcom/qrb4210-rb2.dts
>> +++ b/arch/arm64/boot/dts/qcom/qrb4210-rb2.dts
> 
> [...]
>> @@ -312,11 +385,24 @@ &sleep_clk {
>>  };
>>  
>>  &tlmm {
>> -	gpio-reserved-ranges = <37 5>, <43 2>, <47 1>,
>> +	gpio-reserved-ranges = <43 2>, <47 1>,
> 
> Is this intentional?
Yes, notice how this included the reset pin. These pins are
not even really reserved, there's no FPC on this board..

Konrad
>>  			       <49 1>, <52 1>, <54 1>,
>>  			       <56 3>, <61 2>, <64 1>,
>>  			       <68 1>, <72 8>, <96 1>;
>>  
>> +	lt9611_rst_pin: lt9611-rst-state {
>> +		pins = "gpio41";
>> +		function = "gpio";
>> +		input-disable;
>> +		output-high;
>> +	};
>> +
>> +	lt9611_irq_pin: lt9611-irq-state {
>> +		pins = "gpio46";
>> +		function = "gpio";
>> +		bias-disable;
>> +	};
>> +
>>  	sdc2_card_det_n: sd-card-det-n-state {
>>  		pins = "gpio88";
>>  		function = "gpio";
>>
>