[PATCH 3/3] ARM: dts: qcom: pm8941: Add thermal zone config

[Matti Lehtimäki]

Add thermal zone for the PMIC thermal sensor.

Signed-off-by: Matti Lehtimäki <matti.lehtimaki@xxxxxxxxx>
---
 arch/arm/boot/dts/qcom-pm8941.dtsi | 31 ++++++++++++++++++++++++++++++
 1 file changed, 31 insertions(+)

diff --git a/arch/arm/boot/dts/qcom-pm8941.dtsi b/arch/arm/boot/dts/qcom-pm8941.dtsi
index a821f0368a28..b3e246bacd78 100644
--- a/arch/arm/boot/dts/qcom-pm8941.dtsi
+++ b/arch/arm/boot/dts/qcom-pm8941.dtsi
@@ -3,6 +3,37 @@
 #include <dt-bindings/interrupt-controller/irq.h>
 #include <dt-bindings/spmi/spmi.h>
 
+
+/ {
+	thermal-zones {
+		pm8941-thermal {
+			polling-delay-passive = <100>;
+			polling-delay = <0>;
+			thermal-sensors = <&pm8941_temp>;
+
+			trips {
+				trip0 {
+					temperature = <105000>;
+					hysteresis = <2000>;
+					type = "passive";
+				};
+
+				trip1 {
+					temperature = <125000>;
+					hysteresis = <2000>;
+					type = "hot";
+				};
+
+				crit {
+					temperature = <145000>;
+					hysteresis = <2000>;
+					type = "critical";
+				};
+			};
+		};
+	};
+};
+
 &spmi_bus {
 
 	pm8941_0: pm8941@0 {
-- 
2.34.1