Re: [PATCH] bus: mhi: host: pci_generic: Add support for IP_SW0 channels

[Manivannan Sadhasivam]

On Sun, May 21, 2023 at 08:27:45PM +0200, Loic Poulain wrote:
> On Fri, 19 May 2023 at 15:58, Manivannan Sadhasivam
> <manivannan.sadhasivam@xxxxxxxxxx> wrote:
> >
> > IP_SW0 channels are used to transfer data over the networking interface
> > between MHI endpoint and the host. Define the channels in the MHI v1
> > channel config along with dedicated event rings.
> >
> > Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam@xxxxxxxxxx>
> 
> Assuming we can extend the number of event rings (and dedicated irqs)
> without hitting any hardware limitation on the device side?
> 

Not all endpoints support IP_SW0 channels. Only a few devices that intend to
transfer non-IP data payload supports it and those should take care of the
requirements.

- Mani

> Reviewed-by: Loic Poulain <loic.poulain@xxxxxxxxxx>
> 
> 
> 
> > ---
> >  drivers/bus/mhi/host/pci_generic.c | 26 ++++++++++++++++++++++----
> >  1 file changed, 22 insertions(+), 4 deletions(-)
> >
> > diff --git a/drivers/bus/mhi/host/pci_generic.c b/drivers/bus/mhi/host/pci_generic.c
> > index db0a0b062d8e..70e37c490150 100644
> > --- a/drivers/bus/mhi/host/pci_generic.c
> > +++ b/drivers/bus/mhi/host/pci_generic.c
> > @@ -212,6 +212,19 @@ struct mhi_pci_dev_info {
> >                 .offload_channel = false,       \
> >         }
> >
> > +#define MHI_EVENT_CONFIG_SW_DATA(ev_ring, el_count) \
> > +       {                                       \
> > +               .num_elements = el_count,       \
> > +               .irq_moderation_ms = 0,         \
> > +               .irq = (ev_ring) + 1,           \
> > +               .priority = 1,                  \
> > +               .mode = MHI_DB_BRST_DISABLE,    \
> > +               .data_type = MHI_ER_DATA,       \
> > +               .hardware_event = false,        \
> > +               .client_managed = false,        \
> > +               .offload_channel = false,       \
> > +       }
> > +
> >  #define MHI_EVENT_CONFIG_HW_DATA(ev_ring, el_count, ch_num) \
> >         {                                       \
> >                 .num_elements = el_count,       \
> > @@ -237,8 +250,10 @@ static const struct mhi_channel_config modem_qcom_v1_mhi_channels[] = {
> >         MHI_CHANNEL_CONFIG_DL_AUTOQUEUE(21, "IPCR", 8, 0),
> >         MHI_CHANNEL_CONFIG_UL_FP(34, "FIREHOSE", 32, 0),
> >         MHI_CHANNEL_CONFIG_DL_FP(35, "FIREHOSE", 32, 0),
> > -       MHI_CHANNEL_CONFIG_HW_UL(100, "IP_HW0", 128, 2),
> > -       MHI_CHANNEL_CONFIG_HW_DL(101, "IP_HW0", 128, 3),
> > +       MHI_CHANNEL_CONFIG_UL(46, "IP_SW0", 64, 2),
> > +       MHI_CHANNEL_CONFIG_DL(47, "IP_SW0", 64, 3),
> > +       MHI_CHANNEL_CONFIG_HW_UL(100, "IP_HW0", 128, 4),
> > +       MHI_CHANNEL_CONFIG_HW_DL(101, "IP_HW0", 128, 5),
> >  };
> >
> >  static struct mhi_event_config modem_qcom_v1_mhi_events[] = {
> > @@ -246,9 +261,12 @@ static struct mhi_event_config modem_qcom_v1_mhi_events[] = {
> >         MHI_EVENT_CONFIG_CTRL(0, 64),
> >         /* DIAG dedicated event ring */
> >         MHI_EVENT_CONFIG_DATA(1, 128),
> > +       /* Software channels dedicated event ring */
> > +       MHI_EVENT_CONFIG_SW_DATA(2, 64),
> > +       MHI_EVENT_CONFIG_SW_DATA(3, 64),
> >         /* Hardware channels request dedicated hardware event rings */
> > -       MHI_EVENT_CONFIG_HW_DATA(2, 1024, 100),
> > -       MHI_EVENT_CONFIG_HW_DATA(3, 2048, 101)
> > +       MHI_EVENT_CONFIG_HW_DATA(4, 1024, 100),
> > +       MHI_EVENT_CONFIG_HW_DATA(5, 2048, 101)
> >  };
> >
> >  static const struct mhi_controller_config modem_qcom_v1_mhiv_config = {
> > --
> > 2.25.1
> >

-- 
மணிவண்ணன் சதாசிவம்