Re: [PATCH v1 2/3] drm/msm/dpu: retrieve DSI DSC struct at atomic_check()

[Dmitry Baryshkov]

On Wed, 31 May 2023 at 18:41, Kuogee Hsieh <quic_khsieh@xxxxxxxxxxx> wrote:
>
>
>
> >>   +    if (dpu_enc->disp_info.intf_type == DRM_MODE_ENCODER_DSI) {
> >
> > INTF_DSI
> >
> >> +        struct drm_bridge *bridge;
> >> +
> >> +        if (!dpu_enc->dsc) {
> >
> > This condition is not correct. We should be updating the DSC even if
> > there is one.
> >
> >> +            bridge = drm_bridge_chain_get_first_bridge(drm_enc);
> >> +            dpu_enc->dsc = msm_dsi_bridge_get_dsc_config(bridge);
> >
> > This approach will not work for the hot-pluggable outputs. The dpu_enc
> > is not a part of the state. It should not be touched before
> > atomic_commit actually commits changes.
> where can drm_dsc_config be stored?

I'd say, get it during atomic_check (and don't store it anywhere).
Then get it during atomic_enable (and save in dpu_enc).

> >
> > Also, I don't think I like the API. It makes it impossible for the
> > driver to check that the bridge is the actually our DSI bridge or not.
> > Once you add DP here, the code will explode.
> >
> > I think instead we should extend the drm_bridge API to be able to get
> > the DSC configuration from it directly. Additional care should be put
> > to design an assymetrical API. Theoretically a drm_bridge can be both
> > DSC source and DSC sink. Imagine a DSI-to-DP or DSI-to-HDMI bridge,
> > supporting DSC on the DSI side too.
>
> Form my understanding, a bridge contains two interfaces.
>
> Therefore I would think only one bridge for dsi-to-dp bridge? and this
> bridge should represent the bridge chip?
>
> I am thinking adding an ops function, get_bridge_dsc() to struct
> drm_bridge_funcs to retrieve drm_dsc_config.

So, for this DSI-to-DP bridge will get_bridge_dsc() return DSC
configuration for  the DSI or for the DP side of the bridge?

>
> Do you have other suggestion?

Let me think about it for a few days.

-- 
With best wishes
Dmitry