[PATCH v2 0/5] arm64: dts: ti: k3-j7200: Add properties and sync with uboot

[Udit Kumar]

In continuation of patch series posted by Nishanth
for sync of uboot device tree with kernel device tree for AM64 SOC.
https://lore.kernel.org/linux-arm-kernel/20230414073328.381336-1-nm@xxxxxx/

This series extend device tree sync/clean up for J7200 SOC.

This patch series build on top of
https://lore.kernel.org/all/20230419040007.3022780-1-u-kumar1@xxxxxx


Changes since v1:
https://lore.kernel.org/all/20230426103219.1565266-1-u-kumar1@xxxxxx/
* Add general purpose timers:
  Addded CLKSEL_VD clock for odd numbered timers
  Marked MCU_Timer as reserved, fixed clock index for main_timer13

*Configure pinctrl for timer IO pads
 Marked mcu_timerio_input as reserved

*main_pmx0 clean up
 Splitted into two patches, One for UART and second for
 i2c duplication removal

*Add uart pin mux in wkup_pmx0
  No change

*Add bootph-pre-ram for u-boot
 patch dropped, later will add bootph-pre-ram property
 later for all nodes.


Udit Kumar (5):
  arm64: dts: ti: k3-j7200: Add general purpose timers
  arm64: dts: ti: k3-j7200: Configure pinctrl for timer IO pads
  arm64: dts: ti: k3-j7200-common-proc-board: main_pmx0 clean up
  arm64: dts: ti: k3-j7200-common-proc-board: remove duplicate main_i2c0
    pin mux
  arm64: dts: ti: k3-j7200-common-proc-board: Add uart pin mux in
    wkup_pmx0

 .../dts/ti/k3-j7200-common-proc-board.dts     |  32 ++-
 arch/arm64/boot/dts/ti/k3-j7200-main.dtsi     | 258 ++++++++++++++++++
 .../boot/dts/ti/k3-j7200-mcu-wakeup.dtsi      | 150 ++++++++++
 3 files changed, 436 insertions(+), 4 deletions(-)

-- 
2.34.1