Re: [PATCH v4 07/11] coresight-tpdm: Add nodes for dsb edge control

From: Suzuki K Poulose
Date: Fri Jun 02 2023 - 05:00:44 EST


On 02/06/2023 09:45, Suzuki K Poulose wrote:
On 02/06/2023 09:21, Tao Zhang wrote:

On 6/1/2023 8:14 PM, Suzuki K Poulose wrote:
On 27/04/2023 10:00, Tao Zhang wrote:
Add the nodes to set value for DSB edge control and DSB edge
control mask. Each DSB subunit TPDM has maximum of n(n<16) EDCR
resgisters to configure edge control. DSB edge detection control
00: Rising edge detection
01: Falling edge detection
10: Rising and falling edge detection (toggle detection)
And each DSB subunit TPDM has maximum of m(m<8) ECDMR registers to
configure mask. Eight 32 bit registers providing DSB interface
edge detection mask control.

Signed-off-by: Tao Zhang <quic_taozha@xxxxxxxxxxx>
---
  .../ABI/testing/sysfs-bus-coresight-devices-tpdm   |  32 +++++
  drivers/hwtracing/coresight/coresight-tpdm.c       | 135 ++++++++++++++++++++-
  drivers/hwtracing/coresight/coresight-tpdm.h       |  21 ++++
  3 files changed, 187 insertions(+), 1 deletion(-)

diff --git a/Documentation/ABI/testing/sysfs-bus-coresight-devices-tpdm b/Documentation/ABI/testing/sysfs-bus-coresight-devices-tpdm
index 348e167..a57f000 100644
--- a/Documentation/ABI/testing/sysfs-bus-coresight-devices-tpdm
+++ b/Documentation/ABI/testing/sysfs-bus-coresight-devices-tpdm
@@ -60,3 +60,35 @@ Description:
          Bit[3] : Set to 0 for low performance mode.
                   Set to 1 for high performance mode.
          Bit[4:8] : Select byte lane for high performance mode.
+
+What: /sys/bus/coresight/devices/<tpdm-name>/dsb_edge_ctrl
+Date:        March 2023
+KernelVersion    6.3
+Contact:    Jinlong Mao (QUIC) <quic_jinlmao@xxxxxxxxxxx>, Tao Zhang (QUIC) <quic_taozha@xxxxxxxxxxx>
+Description:
+        Read/Write a set of the edge control registers of the DSB
+        in TPDM.
+
+        Expected format is the following:
+        <integer1> <integer2> <integer3>
+
+        Where:
+        <integer1> : Start EDCR register number
+        <integer2> : End EDCR register number
+        <integer3> : The value need to be written
+
+What: /sys/bus/coresight/devices/<tpdm-name>/dsb_edge_ctrl_mask
+Date:        March 2023
+KernelVersion    6.3
+Contact:    Jinlong Mao (QUIC) <quic_jinlmao@xxxxxxxxxxx>, Tao Zhang (QUIC) <quic_taozha@xxxxxxxxxxx>
+Description:
+        Read/Write a set of the edge control mask registers of the
+        DSB in TPDM.
+
+        Expected format is the following:
+        <integer1> <integer2> <integer3>
+
+        Where:
+        <integer1> : Start EDCMR register number
+        <integer2> : End EDCMR register number
+        <integer3> : The value need to be written
diff --git a/drivers/hwtracing/coresight/coresight-tpdm.c b/drivers/hwtracing/coresight/coresight-tpdm.c
index 1bacaa5..a40e458 100644
--- a/drivers/hwtracing/coresight/coresight-tpdm.c
+++ b/drivers/hwtracing/coresight/coresight-tpdm.c
@@ -80,7 +80,14 @@ static void set_trigger_type(struct tpdm_drvdata *drvdata, u32 *val)
    static void tpdm_enable_dsb(struct tpdm_drvdata *drvdata)
  {
-    u32 val;
+    u32 val, i;
+
+    for (i = 0; i < TPDM_DSB_MAX_EDCR; i++)
+        writel_relaxed(drvdata->dsb->edge_ctrl[i],
+               drvdata->base + TPDM_DSB_EDCR(i));
+    for (i = 0; i < TPDM_DSB_MAX_EDCMR; i++)
+        writel_relaxed(drvdata->dsb->edge_ctrl_mask[i],
+               drvdata->base + TPDM_DSB_EDCMR(i));

Do all TPDM DSBs have MAX_EDCR registers ? Or some have less than that ?
If it is latter, do we need special care to avoid writing to inexistent
registers ?

You are right, not all DSB TPDMs have MAX_EDCR registers. In our design, the inexistent register addresses

are not occupied and safe for accessing.

Does the TRM for the component say so ? Or is it by luck ? If the spec
says it is RAZ/WriteIgnore, then we could keep the code as it is,
with a comment. Otherwise, we could add a DT property. So please get
this clarified with the H/W designers.

Suzuki