Re: [PATCH v2 3/6] clk: qcom: Add lpass clock controller driver for SC8280XP

[Srinivas Kandagatla]

On 31/05/2023 21:01, Krzysztof Kozlowski wrote:
> On 25/05/2023 14:29, Srinivas Kandagatla wrote:
> > Add support for the lpass clock controller found on SC8280XP based devices.
> > This would allow lpass peripheral loader drivers to control the clocks and
> > bring the subsystems out of reset.
> >
> > Currently this patch only supports resets as the Q6DSP is in control of
> > LPASS IP which manages most of the clocks via Q6PRM service on GPR rpmsg
> > channel.
> >
> > Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@xxxxxxxxxx>
> > ---
> >   drivers/clk/qcom/Kconfig            |  8 ++++
> >   drivers/clk/qcom/Makefile           |  1 +
> >   drivers/clk/qcom/lpasscc-sc8280xp.c | 63 +++++++++++++++++++++++++++++
> >   3 files changed, 72 insertions(+)
> >   create mode 100644 drivers/clk/qcom/lpasscc-sc8280xp.c
> >
> > diff --git a/drivers/clk/qcom/Kconfig b/drivers/clk/qcom/Kconfig
> > index 85869e7a9f16..e25993abb519 100644
> > --- a/drivers/clk/qcom/Kconfig
> > +++ b/drivers/clk/qcom/Kconfig
> > @@ -523,6 +523,14 @@ config SC_LPASSCC_7280
> >   	  Say Y if you want to use the LPASS branch clocks of the LPASS clock
> >   	  controller to reset the LPASS subsystem.
> >   
> > +config SC_LPASSCC_8280XP
> > +	tristate "SC8280 Low Power Audio Subsystem (LPASS) Clock Controller"
>
> depends on ARM64 || COMPILE_TEST

Thanks, Will do that in v3.

--srini
> Best regards,
> Krzysztof