[PATCH v8 10/10] serial: sc16is7xx: improve comments about variants
From: Hugo Villeneuve
Date: Wed Jun 07 2023 - 10:06:23 EST
From: Hugo Villeneuve <hvilleneuve@xxxxxxxxxxxx>
Replace 740/750/760 with generic terms like 74x/75x/76x to account for
variants like 741, 752 and 762.
Signed-off-by: Hugo Villeneuve <hvilleneuve@xxxxxxxxxxxx>
Reviewed-by: Lech Perczak <lech.perczak@xxxxxxxxxxxxxxx>
---
drivers/tty/serial/sc16is7xx.c | 8 ++++----
1 file changed, 4 insertions(+), 4 deletions(-)
diff --git a/drivers/tty/serial/sc16is7xx.c b/drivers/tty/serial/sc16is7xx.c
index 7616703f7438..c9edc51870ca 100644
--- a/drivers/tty/serial/sc16is7xx.c
+++ b/drivers/tty/serial/sc16is7xx.c
@@ -223,7 +223,7 @@
* trigger levels. Trigger levels from 4 characters to 60 characters are
* available with a granularity of four.
*
- * When the trigger level setting in TLR is zero, the SC16IS740/750/760 uses the
+ * When the trigger level setting in TLR is zero, the SC16IS74x/75x/76x uses the
* trigger level setting defined in FCR. If TLR has non-zero trigger level value
* the trigger level defined in FCR is discarded. This applies to both transmit
* FIFO and receive FIFO trigger level setting.
@@ -234,7 +234,7 @@
#define SC16IS7XX_TLR_TX_TRIGGER(words) ((((words) / 4) & 0x0f) << 0)
#define SC16IS7XX_TLR_RX_TRIGGER(words) ((((words) / 4) & 0x0f) << 4)
-/* IOControl register bits (Only 750/760) */
+/* IOControl register bits (Only 75x/76x) */
#define SC16IS7XX_IOCONTROL_LATCH_BIT (1 << 0) /* Enable input latching */
#define SC16IS7XX_IOCONTROL_MODEM_A_BIT (1 << 1) /* Enable GPIO[7:4] as modem A pins */
#define SC16IS7XX_IOCONTROL_MODEM_B_BIT (1 << 2) /* Enable GPIO[3:0] as modem B pins */
@@ -249,9 +249,9 @@
#define SC16IS7XX_EFCR_RTS_INVERT_BIT (1 << 5) /* RTS output inversion */
#define SC16IS7XX_EFCR_IRDA_MODE_BIT (1 << 7) /* IrDA mode
* 0 = rate upto 115.2 kbit/s
- * - Only 750/760
+ * - Only 75x/76x
* 1 = rate upto 1.152 Mbit/s
- * - Only 760
+ * - Only 76x
*/
/* EFR register bits */
--
2.30.2