Re: [PATCH 10/12] mtd: rawnand: brcmnand: Add BCMBCA read data bus interface

From: William Zhang
Date: Wed Jun 07 2023 - 16:25:17 EST


Hi Miquel,

On 06/07/2023 01:22 AM, Miquel Raynal wrote:
Hi William,

william.zhang@xxxxxxxxxxxx wrote on Tue, 6 Jun 2023 16:12:50 -0700:

The BCMBCA broadband SoC integrates the NAND controller differently than
STB, iProc and other SoCs. It has different endianness for NAND cache
data and ONFI parameter data.

Add a SoC read data bus shim for BCMBCA to meet the specific SoC need
and performance improvement using the optimized memcpy function on NAND
cache memory.

Signed-off-by: William Zhang <william.zhang@xxxxxxxxxxxx>
---

drivers/mtd/nand/raw/brcmnand/bcmbca_nand.c | 36 +++++++++++++++++
drivers/mtd/nand/raw/brcmnand/brcmnand.c | 44 ++++++++++++++-------
drivers/mtd/nand/raw/brcmnand/brcmnand.h | 2 +
3 files changed, 68 insertions(+), 14 deletions(-)

diff --git a/drivers/mtd/nand/raw/brcmnand/bcmbca_nand.c b/drivers/mtd/nand/raw/brcmnand/bcmbca_nand.c
index 7e48b6a0bfa2..899103a62c98 100644
--- a/drivers/mtd/nand/raw/brcmnand/bcmbca_nand.c
+++ b/drivers/mtd/nand/raw/brcmnand/bcmbca_nand.c
@@ -26,6 +26,18 @@ enum {
BCMBCA_CTLRDY = BIT(4),
};
+#if defined(CONFIG_ARM64)
+#define ALIGN_REQ 8
+#else
+#define ALIGN_REQ 4
+#endif
+
+static inline bool bcmbca_nand_is_buf_aligned(void *flash_cache, void *buffer)
+{
+ return IS_ALIGNED((uintptr_t)buffer, ALIGN_REQ) &&
+ IS_ALIGNED((uintptr_t)flash_cache, ALIGN_REQ);
+}
+
static bool bcmbca_nand_intc_ack(struct brcmnand_soc *soc)
{
struct bcmbca_nand_soc *priv =
@@ -56,6 +68,29 @@ static void bcmbca_nand_intc_set(struct brcmnand_soc *soc, bool en)
brcmnand_writel(val, mmio);
}
+static void bcmbca_read_data_bus(struct brcmnand_soc *soc,
+ void __iomem *flash_cache, u32 *buffer,
+ int fc_words, bool is_param)
+{
+ int i;
+
+ if (!is_param) {
+ /*
+ * memcpy can do unaligned aligned access depending on source
+ * and dest address, which is incompatible with nand cache. Fallback
+ * to the memcpy for io version
+ */
+ if (bcmbca_nand_is_buf_aligned(flash_cache, buffer))
+ memcpy((void *)buffer, (void *)flash_cache, fc_words * 4);
+ else
+ memcpy_fromio((void *)buffer, (void *)flash_cache, fc_words * 4);
+ } else {
+ /* Flash cache has same endian as the host for parameter pages */
+ for (i = 0; i < fc_words; i++, buffer++)
+ *buffer = __raw_readl(flash_cache + i * 4);
+ }
+}
+
static int bcmbca_nand_probe(struct platform_device *pdev)
{
struct device *dev = &pdev->dev;
@@ -75,6 +110,7 @@ static int bcmbca_nand_probe(struct platform_device *pdev)
soc->ctlrdy_ack = bcmbca_nand_intc_ack;
soc->ctlrdy_set_enabled = bcmbca_nand_intc_set;
+ soc->read_data_bus = bcmbca_read_data_bus;
return brcmnand_probe(pdev, soc);
}
diff --git a/drivers/mtd/nand/raw/brcmnand/brcmnand.c b/drivers/mtd/nand/raw/brcmnand/brcmnand.c
index d920e88c7f5b..656be4d73016 100644
--- a/drivers/mtd/nand/raw/brcmnand/brcmnand.c
+++ b/drivers/mtd/nand/raw/brcmnand/brcmnand.c
@@ -814,6 +814,30 @@ static inline u32 edu_readl(struct brcmnand_controller *ctrl,
return brcmnand_readl(ctrl->edu_base + offs);
}
+static inline void brcmnand_read_data_bus(struct brcmnand_controller *ctrl,
+ void __iomem *flash_cache, u32 *buffer,
+ int fc_words, bool is_param)
+{
+ struct brcmnand_soc *soc = ctrl->soc;
+ int i;
+
+ if (soc->read_data_bus) {
+ soc->read_data_bus(soc, flash_cache, buffer, fc_words, is_param);
+ } else {
+ if (!is_param) {
+ for (i = 0; i < fc_words; i++, buffer++)
+ *buffer = brcmnand_read_fc(ctrl, i);
+ } else {
+ for (i = 0; i < fc_words; i++)
+ /*
+ * Flash cache is big endian for parameter pages, at
+ * least on STB SoCs
+ */
+ buffer[i] = be32_to_cpu(brcmnand_read_fc(ctrl, i));
+ }
+ }

Perhaps we could have a single function that is statically assigned at
probe time instead of a first helper with two conditions which calls in
one case another hook... This can be simplified I guess.

Well this will need to be done at the SoC specific implementation level (bcm<xxx>_nand.c) and each SoC will need to have either general data bus read func with is_param option or data_bus_read_page, data_bus_read_param. Not sure how much this can be simplified... Or we have default implementation in brcmnand.c but then there is one condition check too. Page read is done at 512 bytes burst. One or two conditions check outside of the per 512 bytes read loop does not sounds too bad if performance is concern.

+}
+
static void brcmnand_clear_ecc_addr(struct brcmnand_controller *ctrl)
{
@@ -1811,20 +1835,11 @@ static void brcmnand_cmdfunc(struct nand_chip *chip, unsigned command,
native_cmd == CMD_PARAMETER_CHANGE_COL) {
/* Copy flash cache word-wise */
u32 *flash_cache = (u32 *)ctrl->flash_cache;
- int i;
brcmnand_soc_data_bus_prepare(ctrl->soc, true);
- /*
- * Must cache the FLASH_CACHE now, since changes in
- * SECTOR_SIZE_1K may invalidate it
- */
- for (i = 0; i < FC_WORDS; i++)
- /*
- * Flash cache is big endian for parameter pages, at
- * least on STB SoCs
- */
- flash_cache[i] = be32_to_cpu(brcmnand_read_fc(ctrl, i));
+ brcmnand_read_data_bus(ctrl, ctrl->nand_fc, flash_cache,
+ FC_WORDS, true);
brcmnand_soc_data_bus_unprepare(ctrl->soc, true);
@@ -2137,7 +2152,7 @@ static int brcmnand_read_by_pio(struct mtd_info *mtd, struct nand_chip *chip,
{
struct brcmnand_host *host = nand_get_controller_data(chip);
struct brcmnand_controller *ctrl = host->ctrl;
- int i, j, ret = 0;
+ int i, ret = 0;
brcmnand_clear_ecc_addr(ctrl);
@@ -2150,8 +2165,9 @@ static int brcmnand_read_by_pio(struct mtd_info *mtd, struct nand_chip *chip,
if (likely(buf)) {
brcmnand_soc_data_bus_prepare(ctrl->soc, false);
- for (j = 0; j < FC_WORDS; j++, buf++)
- *buf = brcmnand_read_fc(ctrl, j);
+ brcmnand_read_data_bus(ctrl, ctrl->nand_fc, buf,
+ FC_WORDS, false);
+ buf += FC_WORDS;
brcmnand_soc_data_bus_unprepare(ctrl->soc, false);
}
diff --git a/drivers/mtd/nand/raw/brcmnand/brcmnand.h b/drivers/mtd/nand/raw/brcmnand/brcmnand.h
index f1f93d85f50d..88819bc395f8 100644
--- a/drivers/mtd/nand/raw/brcmnand/brcmnand.h
+++ b/drivers/mtd/nand/raw/brcmnand/brcmnand.h
@@ -24,6 +24,8 @@ struct brcmnand_soc {
void (*ctlrdy_set_enabled)(struct brcmnand_soc *soc, bool en);
void (*prepare_data_bus)(struct brcmnand_soc *soc, bool prepare,
bool is_param);
+ void (*read_data_bus)(struct brcmnand_soc *soc, void __iomem *flash_cache,
+ u32 *buffer, int fc_words, bool is_param);
const struct brcmnand_io_ops *ops;
};


Thanks,
Miquèl

Attachment: smime.p7s
Description: S/MIME Cryptographic Signature