Re: [PATCH v2 1/2] dt-bindings: mtd: jedec, spi-nor: Add DT property to avoid setting SRWD bit in status register

[Rob Herring]

On Fri, Jun 16, 2023 at 02:25:12PM +0530, Amit Kumar Mahapatra wrote:
> If the WP signal of the flash device is not connected and the software sets
> the status register write disable (SRWD) bit in the status register then
> thestatus register permanently becomes read-only. To avoid this added a new
> boolean DT property "broken-wp". If WP signal is not connected, then this
> property should be set in the DT to avoid setting the SRWD during status
> register write operation.
> 
> Signed-off-by: Amit Kumar Mahapatra <amit.kumar-mahapatra@xxxxxxx>
> Reviewed-by: Conor Dooley <conor.dooley@xxxxxxxxxxxxx>
> ---
>  .../devicetree/bindings/mtd/jedec,spi-nor.yaml    | 15 +++++++++++++++
>  1 file changed, 15 insertions(+)
> 
> diff --git a/Documentation/devicetree/bindings/mtd/jedec,spi-nor.yaml b/Documentation/devicetree/bindings/mtd/jedec,spi-nor.yaml
> index 89959e5c47ba..10a6df752f6f 100644
> --- a/Documentation/devicetree/bindings/mtd/jedec,spi-nor.yaml
> +++ b/Documentation/devicetree/bindings/mtd/jedec,spi-nor.yaml
> @@ -70,6 +70,21 @@ properties:
>        be used on such systems, to denote the absence of a reliable reset
>        mechanism.
>  
> +  broken-wp:

In the tied low case, that's designed behavior rather than broken. The 
name should reflect that.

> +    type: boolean
> +    description:
> +      The status register write disable (SRWD) bit in status register, combined
> +      with the WP signal, provides hardware data protection for the device. When
> +      the SRWD bit is set to 1, and the WP signal is either driven LOW or hard
> +      strapped to LOW, the status register nonvolatile bits become read-only and
> +      the WRITE STATUS REGISTER operation will not execute. The only way to exit
> +      this hardware-protected mode is to drive WP HIGH. If the WP signal of the
> +      flash device is not connected then status register permanently becomes
> +      read-only as the SRWD bit cannot be reset. This boolean flag can be used
> +      on systems in which WP signal is not connected, to avoid setting the SRWD
> +      bit while writing the status register. If the WP signal is hard strapped
> +      to LOW then it is not broken as it can be a valid use case.
> +
>    reset-gpios:
>      description:
>        A GPIO line connected to the RESET (active low) signal of the device.
> -- 
> 2.17.1
>