Re: [PATCH v9 10/10] arm64: dts: qcom: sa8540-ride: Enable first port of tertiary usb controller

[Krishna Kurapati PSSNV]

On 6/24/2023 4:12 AM, Konrad Dybcio wrote:
> On 21.06.2023 06:36, Krishna Kurapati wrote:
> > There is now support for the multiport USB controller this uses so
> > enable it.
> >
> > The board only has a single port hooked up (despite it being wired up to
> > the multiport IP on the SoC). There's also a USB 2.0 mux hooked up,
> > which by default on boot is selected to mux properly. Grab the gpio
> > controlling that and ensure it stays in the right position so USB 2.0
> > continues to be routed from the external port to the SoC.
> >
> > Signed-off-by: Andrew Halaney <ahalaney@xxxxxxxxxx>
> > [Krishna: Rebased on top of usb-next]
> If that's your only change to this patch, you should have kept the
> Author: field unchanged.
Sure, will do reset-author and resubmit the patch next version.

> > Signed-off-by: Krishna Kurapati <quic_kriskura@xxxxxxxxxxx>
> > ---
> Same comments as patch 9
>
> Konrad

Thanks for the review.

Regards,
Krishna,
> >   arch/arm64/boot/dts/qcom/sa8540p-ride.dts | 22 ++++++++++++++++++++++
> >   1 file changed, 22 insertions(+)
> >
> > diff --git a/arch/arm64/boot/dts/qcom/sa8540p-ride.dts b/arch/arm64/boot/dts/qcom/sa8540p-ride.dts
> > index 24fa449d48a6..53d47593306e 100644
> > --- a/arch/arm64/boot/dts/qcom/sa8540p-ride.dts
> > +++ b/arch/arm64/boot/dts/qcom/sa8540p-ride.dts
> > @@ -309,6 +309,19 @@ &usb_2_qmpphy0 {
> >   	status = "okay";
> >   };
> >   
> > +&usb_2 {
> > +	pinctrl-names = "default";
> > +	pinctrl-0 = <&usb2_en_state>;
> > +
> > +	status = "okay";
> > +};
> > +
> > +&usb_2_dwc3 {
> > +	dr_mode = "host";
> > +	phy-names = "usb2-port0", "usb3-port0";
> > +	phys = <&usb_2_hsphy0>, <&usb_2_qmpphy0>;
> > +};
> > +
> >   &xo_board_clk {
> >   	clock-frequency = <38400000>;
> >   };
> > @@ -401,4 +414,13 @@ wake-pins {
> >   			bias-pull-up;
> >   		};
> >   	};
> > +
> > +	usb2_en_state: usb2-en-state {
> > +		/* TS3USB221A USB2.0 mux select */
> > +		pins = "gpio24";
> > +		function = "gpio";
> > +		drive-strength = <2>;
> > +		bias-disable;
> > +		output-low;
> > +	};
> >   };