Re: [PATCH v4] arm64: dts: ti: k3-j721s2: Add support for CAN instances 3 and 5 in main domain

[Kumar, Udit]

Hi Bhavya

On 6/23/2023 12:21 AM, Bhavya Kapoor wrote:
> CAN instances 3 and 5 in the main domain are brought on the common
> processor board through header J27 and J28. The CAN High and Low lines
> from the SoC are routed through a mux on the SoM. The select lines need
> to be set for the CAN signals to get connected to the transceivers on
> the common processor board. Threfore, add respective mux, transceiver
> dt nodes to add support for these CAN instances.
> [...]
>   
> +	mux0: mux-controller@0 {
> +		compatible = "gpio-mux";
> +		#mux-state-cells = <1>;
> +		mux-gpios = <&exp_som 1 GPIO_ACTIVE_HIGH>;
> +	};
> +


You will get more warning with @0 and @1

  DTC_CHK arch/arm64/boot/dts/ti//k3-j721s2-common-proc-board.dtb
/arch/arm64/boot/dts/ti/k3-j721s2-common-proc-board.dtb: /: 
mux-controller@0: 'anyOf' conditional failed, one must be fixed:
        'reg' is a required property
        'ranges' is a required property
        From schema: 
/home/udit/.local/lib/python3.10/site-packages/dtschema/schemas/root-node.yaml
/arch/arm64/boot/dts/ti/k3-j721s2-common-proc-board.dtb: /: 
mux-controller@1: 'anyOf' conditional failed, one must be fixed:
        'reg' is a required property
        'ranges' is a required property

> +	mux1: mux-controller@1 {
> +		compatible = "gpio-mux";
> +		#mux-state-cells = <1>;
> +		mux-gpios = <&exp_som 2 GPIO_ACTIVE_HIGH>;
> +	};
> +
>   	transceiver0: can-phy0 {
>   		/* standby pin has been grounded by default */
>   		compatible = "ti,tcan1042";