Re: [RFC PATCH v2 1/2] dt-bindings: nand: meson: support for 512B ECC step size

[Miquel Raynal]

Hi Arseniy,

AVKrasnov@xxxxxxxxxxxxxx wrote on Wed, 5 Jul 2023 09:54:33 +0300:

> Meson NAND supports both 512B and 1024B ECC step size, so replace
> 'const' for only 1024B step size with enum for both sizes.
> 
> Signed-off-by: Arseniy Krasnov <AVKrasnov@xxxxxxxxxxxxxx>
> ---
>  Documentation/devicetree/bindings/mtd/amlogic,meson-nand.yaml | 4 +++-
>  1 file changed, 3 insertions(+), 1 deletion(-)
> 
> diff --git a/Documentation/devicetree/bindings/mtd/amlogic,meson-nand.yaml b/Documentation/devicetree/bindings/mtd/amlogic,meson-nand.yaml
> index 3bec8af91bbb..81ca8828731a 100644
> --- a/Documentation/devicetree/bindings/mtd/amlogic,meson-nand.yaml
> +++ b/Documentation/devicetree/bindings/mtd/amlogic,meson-nand.yaml
> @@ -49,7 +49,8 @@ patternProperties:
>          const: hw
>  
>        nand-ecc-step-size:
> -        const: 1024
> +        enum: [512, 1024]
> +        default: 1024

I was actually wrong in my previous review, there is no strong default
here as the existing binding (and code) try to use the closest
parameters required by the NAND chip: we pick the "optimal"
configuration. So if you don't provide any value here, we expect
the strength and step size advertized by the chip to be used. This is a
common default in the raw NAND subsystem.

Please drop the default line, re-integrate the missing R-by tag from
Rob and in a separate patch please mark nand-ecc-step-size and
nand-ecc-strength mandatory if the other is provide. IOW, we expect
either both, or none of them, but not a single one.

>  
>        nand-ecc-strength:
>          enum: [8, 16, 24, 30, 40, 50, 60]
> @@ -93,6 +94,7 @@ examples:
>        nand@0 {
>          reg = <0>;
>          nand-rb = <0>;
> +        nand-ecc-step-size = <1024>;

So in the end this line is wrong and once you get the description right
as I mentioned it above, this will fail to pass
`make DT_SCHEMA_FILES=Documentation/devicetree/bindings/mtd/ dt_binidng_check`
Please drop it from the example, don't add the second property here,
it's best to show a clean example where people stop tampering for no
reason with the optimal values.

>        };
>      };
>  


Thanks,
Miquèl