[PATCH] net: phy: Don't disable irqs on shutdown if WoL is enabled

[Uwe Kleine-König]

Most PHYs signal WoL using an interrupt. So disabling interrupts breaks
WoL at least on PHYs covered by the marvell driver. So skip disabling
irqs on shutdown if WoL is enabled.

While at it also explain the motivation that irqs are disabled at all.

Fixes: e2f016cf7751 ("net: phy: add a shutdown procedure")
Signed-off-by: Uwe Kleine-König <u.kleine-koenig@xxxxxxxxxxxxxx>
---
Hello,

while I'm not sure that disabling interrupts is a good idea in general,
this change at least should fix the WoL case. Note that this change is
only compile tested as next doesn't boot on my test machine (because of
https://git.kernel.org/linus/b3574f579ece24439c90e9a179742c61205fbcfa)
and 6.1 (which is the other kernel I have running) doesn't know about
.wol_enabled. I don't want to delay this fix until I bisected this new
issue.

Assuming this patch is eligible for backporting to stable, maybe point
out that it depends on v6.5-rc1~163^2~286^2~2 ("net: phy: Allow drivers
to always call into ->suspend()"). Didn't try to backport that.

Best regards
Uwe

 drivers/net/phy/phy_device.c | 9 +++++++++
 1 file changed, 9 insertions(+)

diff --git a/drivers/net/phy/phy_device.c b/drivers/net/phy/phy_device.c
index 61921d4dbb13..6d1526bdd1d7 100644
--- a/drivers/net/phy/phy_device.c
+++ b/drivers/net/phy/phy_device.c
@@ -3340,6 +3340,15 @@ static void phy_shutdown(struct device *dev)
 	if (phydev->state == PHY_READY || !phydev->attached_dev)
 		return;
 
+	/* Most phys signal WoL via the irq line. So for these irqs shouldn't be
+	 * disabled.
+	 */
+	if (phydev->wol_enabled)
+		return;
+
+	/* On shutdown disable irqs to prevent an irq storm on systems where the
+	 * irq line is shared by several devices.
+	 */
 	phy_disable_interrupts(phydev);
 }
 
-- 
2.40.1