Re: [PATCH v2 07/13] arm64: dts: ti: k3-am64: Enable OSPI nodes at the board level

[Andrew Davis]

On 8/8/23 9:17 AM, Nishanth Menon wrote:
> On 09:13-20230808, Andrew Davis wrote:
> > On 8/8/23 8:34 AM, Andrew Davis wrote:
> > > OSPI nodes defined in the top-level AM64 SoC dtsi files are incomplete
> > > and may not be functional unless they are extended with pinmux and
> > > device information.
> > >
> > > As the attached OSPI device is only known about at the board integration
> > > level, these nodes should only be enabled when provided with this
> > > information.
> > >
> > > Disable the OSPI nodes in the dtsi files and only enable the ones that
> > > are actually pinned out on a given board.
> > >
> > > Signed-off-by: Andrew Davis <afd@xxxxxx>
> > > Reviewed-by: Dhruva Gole <d-gole@xxxxxx>
> > > ---
> >
> > Oops, I see we have a new AM64 board in -next (tqma64xxl), I can either
> > rebase this again and enable the nodes in there. Or you can skip this
> > and the other AM64 patch in this series and I'll resend them next cycle
> > when that new board is settled.
>
> we should respin this series taking the new boards into consideration -
> am64 and am62 both have new boards.

No problem, v3 on the way.

Andrew