Re: [PATCH 3/3] gpio: sprd: Add clear interrupt

[wenhua lin]

On Thu, Aug 10, 2023 at 5:57 PM Andy Shevchenko
<andy.shevchenko@xxxxxxxxx> wrote:
>
> On Thu, Aug 10, 2023 at 10:27 AM wenhua lin <wenhua.lin1994@xxxxxxxxx> wrote:
> > On Tue, Aug 8, 2023 at 9:25 PM Andy Shevchenko <andy@xxxxxxxxxx> wrote:
> > > On Tue, Aug 08, 2023 at 11:31:44AM +0800, Wenhua Lin wrote:
> > > > Clear interrupt after set the interrupt type.
> > >
> > > Why?
> > >
> > > Can't it be done in the ->init_hw() callback of GPIO IRQ chip?
> >
> > Hi Andy:
> > The initialization state of EIC is high-level trigger. If the external
> > level is high and the interrupt condition is met,
> > EIC has a latch function. If the module registers the eic interrupt,
> > an interrupt will be generated immediately
> >  as soon as the eic interrupt is enabled. To solve this problem, our
> > processing method is to clear the interrupt
> >  once when setting the interrupt trigger type, in order to avoid that
> > this interrupt is the last interrupt.
>
> Obvious question, isn't this needed to be added to ->init_hw() as well?

In the ->init_hw() function, the sprd_gpio_irq_ack interface will be called
 to clear the interrupt, and there is no need to add it repeatedly

>
> --
> With Best Regards,
> Andy Shevchenko