Re: [PATCH V2 0/3] Add binding header file for GPIO interrupt of Amlogic Meson-G12A

[neil . armstrong]

On 07/08/2023 15:37, Linus Walleij wrote:
> On Mon, Jul 24, 2023 at 8:02 AM Huqiang Qin <huqiang.qin@xxxxxxxxxxx> wrote:
>
> > After adding this binding header file, you can intuitively find
> > the interrupt number corresponding to each GPIO, and apply it
> > in the format of IRQID_XXX where it needs to be used.
> (...)
>
> > Huqiang Qin (3):
> >    dt-bindings: interrupt-controller: Add header file for Amlogic
> >      Meson-G12A SoCs
> >    pinctrl: Replace the IRQ number in the driver with the IRQID macro
> >      definition
> >    arm64: dts: Replace the IRQ number with the IRQID macro definition
>
> Neil wrote:
> > What's the best way to apply this patchset ?
>
> I just applied all three to the pin control tree.
>
> I could have applied just the two first and then offered an
> immutable branch. But eh... too much work for too low risk.
> Better to just apply it and hope all works out. If it explodes
> I just back out and figure something like the above.

Perfect, thx :-)

Neil

> Yours,
> Linus Walleij