Re: [PATCH] mmc: sdhci-esdhc-imx: improve ESDHC_FLAG_ERR010450

[Adrian Hunter]

On 12/08/23 00:48, Giulio Benetti wrote:
> Errata ERR010450 only shows up if voltage is 1.8V, but if the device is
> supplied by 3v3 the errata can be ignored. So let's check for if quirk
> SDHCI_QUIRK2_NO_1_8_V is defined or not before limiting the frequency.
> 
> Sponsored by: Tekvox Inc.
> Cc: Jim Reinhart <jimr@xxxxxxxxxx>
> Cc: James Autry <jautry@xxxxxxxxxx>
> Cc: Matthew Maron <matthewm@xxxxxxxxxx>
> Signed-off-by: Giulio Benetti <giulio.benetti@xxxxxxxxxxxxxxxxxxxxxx>

Haibo Chen, can we get an Acked-by from you?

> ---
>  drivers/mmc/host/sdhci-esdhc-imx.c | 7 ++++---
>  1 file changed, 4 insertions(+), 3 deletions(-)
> 
> diff --git a/drivers/mmc/host/sdhci-esdhc-imx.c b/drivers/mmc/host/sdhci-esdhc-imx.c
> index eebf94604a7f..cddecc1e1ac2 100644
> --- a/drivers/mmc/host/sdhci-esdhc-imx.c
> +++ b/drivers/mmc/host/sdhci-esdhc-imx.c
> @@ -171,8 +171,8 @@
>  #define ESDHC_FLAG_HS400		BIT(9)
>  /*
>   * The IP has errata ERR010450
> - * uSDHC: Due to the I/O timing limit, for SDR mode, SD card clock can't
> - * exceed 150MHz, for DDR mode, SD card clock can't exceed 45MHz.
> + * uSDHC: At 1.8V due to the I/O timing limit, for SDR mode, SD card
> + * clock can't exceed 150MHz, for DDR mode, SD card clock can't exceed 45MHz.
>   */
>  #define ESDHC_FLAG_ERR010450		BIT(10)
>  /* The IP supports HS400ES mode */
> @@ -961,7 +961,8 @@ static inline void esdhc_pltfm_set_clock(struct sdhci_host *host,
>  		| ESDHC_CLOCK_MASK);
>  	sdhci_writel(host, temp, ESDHC_SYSTEM_CONTROL);
>  
> -	if (imx_data->socdata->flags & ESDHC_FLAG_ERR010450) {
> +	if ((imx_data->socdata->flags & ESDHC_FLAG_ERR010450) &&
> +	    (!(host->quirks2 & SDHCI_QUIRK2_NO_1_8_V))) {
>  		unsigned int max_clock;
>  
>  		max_clock = imx_data->is_ddr ? 45000000 : 150000000;