[PATCH v3 06/41] drm: renesas: shmobile: Correct encoder/connector types

[Geert Uytterhoeven]

The first encoder output on the SH-Mobile LCD Controller is a DPI
parallel bus.  However, at the time of introduction of the driver, no
encoder or connector types were defined yet for the DPI parallel bus,
hence the driver used the ones for LVDS instead.

Adjust the types accordingly.

Signed-off-by: Geert Uytterhoeven <geert+renesas@xxxxxxxxx>
Reviewed-by: Laurent Pinchart <laurent.pinchart+renesas@xxxxxxxxxxxxxxxx>
---
v3:
  - No changes,

v2:
  - Add Reviewed-by.
---
 drivers/gpu/drm/renesas/shmobile/shmob_drm_crtc.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/gpu/drm/renesas/shmobile/shmob_drm_crtc.c b/drivers/gpu/drm/renesas/shmobile/shmob_drm_crtc.c
index 11dd2bc803e7cb62..fbfd906844da490c 100644
--- a/drivers/gpu/drm/renesas/shmobile/shmob_drm_crtc.c
+++ b/drivers/gpu/drm/renesas/shmobile/shmob_drm_crtc.c
@@ -598,7 +598,7 @@ int shmob_drm_encoder_create(struct shmob_drm_device *sdev)
 	encoder->possible_crtcs = 1;
 
 	ret = drm_simple_encoder_init(sdev->ddev, encoder,
-				      DRM_MODE_ENCODER_LVDS);
+				      DRM_MODE_ENCODER_DPI);
 	if (ret < 0)
 		return ret;
 
@@ -684,7 +684,7 @@ int shmob_drm_connector_create(struct shmob_drm_device *sdev,
 	connector->display_info.height_mm = sdev->pdata->panel.height_mm;
 
 	ret = drm_connector_init(sdev->ddev, connector, &connector_funcs,
-				 DRM_MODE_CONNECTOR_LVDS);
+				 DRM_MODE_CONNECTOR_DPI);
 	if (ret < 0)
 		return ret;
 
-- 
2.34.1