[PATCH 7/8] i2c: sprd: Set I2C_RX_ACK when clear irq

[Huangzheng Lai]

We found that when clearing the I2C_TX_ACK bit, the I2C_MODE bit will
also be cleared to 0. When the IIC master reads data, this situation
will cause the FIFO of the IIC to be empty after clearing the interrupt.
To address this issue, when clearing interrupts, set I2C_RX_ACK bit to 1,
as writing 1 to this bit will not take effect.

Signed-off-by: Huangzheng Lai <Huangzheng.Lai@xxxxxxxxxx>
---
 drivers/i2c/busses/i2c-sprd.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/i2c/busses/i2c-sprd.c b/drivers/i2c/busses/i2c-sprd.c
index d867389c7f17..6f65f28ea69d 100644
--- a/drivers/i2c/busses/i2c-sprd.c
+++ b/drivers/i2c/busses/i2c-sprd.c
@@ -138,7 +138,7 @@ static void sprd_i2c_clear_irq(struct sprd_i2c *i2c_dev)
 {
 	u32 tmp = readl(i2c_dev->base + I2C_STATUS);
 
-	writel(tmp & ~I2C_INT, i2c_dev->base + I2C_STATUS);
+	writel((tmp & ~I2C_INT) | I2C_RX_ACK, i2c_dev->base + I2C_STATUS);
 }
 
 static void sprd_i2c_reset_fifo(struct sprd_i2c *i2c_dev)
-- 
2.17.1