Re: [PATCH v2] irqchip/qcom-pdc: add support for v3.2 HW

[Maulik Shah (mkshah)]

Hi Neil,

@@ -142,8 +163,17 @@ static int qcom_pdc_gic_set_type(struct irq_data 
*d, unsigned int type)
>   		return -EINVAL;
>   	}
>   
> -	old_pdc_type = pdc_reg_read(IRQ_i_CFG, d->hwirq);
> -	pdc_reg_write(IRQ_i_CFG, d->hwirq, pdc_type);
> +	if (pdc_version < PDC_VERSION_3_2) {
> +		old_pdc_type = pdc_reg_read(IRQ_i_CFG, d->hwirq);
> +		pdc_reg_write(IRQ_i_CFG, d->hwirq, pdc_type);
> +	} else {
> +		u32 val;
> +
> +		val = pdc_reg_read(IRQ_i_CFG, d->hwirq);
> +		old_pdc_type = val & IRQ_i_CFG_TYPE_MASK;
> +		pdc_reg_write(IRQ_i_CFG, d->hwirq,
> +			      pdc_type | (val & IRQ_i_CFG_IRQ_ENABLE));
> +	}
While above is correct, i don't think we need version check in 
qcom_pdc_gic_set_type() as bits 0-2 are always for the type in old/new 
version as mentioned in v1.

Adding one line after reading old_pdc_type should be good enough.

  old_pdc_type = pdc_reg_read(IRQ_i_CFG, d->hwirq);
+ pdc_type |= (old_pdc_type & ~IRQ_i_CFG_TYPE_MASK);
> +			if (pdc_version < PDC_VERSION_3_2) {
> +				u32 irq_index, reg_index;
> +
> +				reg_index = (i + pdc_region[n].pin_base) >> 5;
> +				irq_index = (i + pdc_region[n].pin_base) & 0x1f;
> +				val = pdc_reg_read(IRQ_ENABLE_BANK, reg_index);
> +				val &= ~BIT(irq_index);
can use  __assign_bit(irq_index, &val, 0); here.
> +				pdc_reg_write(IRQ_ENABLE_BANK, reg_index, val);
> +			} else {
> +				u32 irq;
> +
> +				irq = i + pdc_region[n].pin_base;
> +				val = pdc_reg_read(IRQ_i_CFG, irq);
> +				val &= ~IRQ_i_CFG_IRQ_ENABLE;

__assign_bit(IRQ_i_CFG_IRQ_ENABLE, &val,  0); here.

other than this..
Reviewed-by: Maulik Shah <quic_mkshah@xxxxxxxxxxx>

Thanks,
Maulik