[PATCH 2/2] arm: dts: am3517-evm: Enable Ethernet PHY Interrupt

[Adam Ford]

The Ethernet PHY interrupt pin is routed to GPIO_58.  Create a
PHY node to configure this GPIO for the interrupt to avoid polling.

Signed-off-by: Adam Ford <aford173@xxxxxxxxx>

diff --git a/arch/arm/boot/dts/ti/omap/am3517-evm.dts b/arch/arm/boot/dts/ti/omap/am3517-evm.dts
index 738189ddc8d5..19869ef906a8 100644
--- a/arch/arm/boot/dts/ti/omap/am3517-evm.dts
+++ b/arch/arm/boot/dts/ti/omap/am3517-evm.dts
@@ -172,11 +172,24 @@ hsusb1_phy: hsusb1_phy {
 &davinci_emac {
 	pinctrl-names = "default";
 	pinctrl-0 = <&ethernet_pins>;
+	phy-mode = "rmii";
+	phy-handle = <&ethphy0>;
 	status = "okay";
 };
 
 &davinci_mdio {
+	#address-cells = <1>;
+	#size-cells = <0>;
 	status = "okay";
+
+	ethphy0: ethernet-phy@0 {
+		pinctrl-names = "default";
+		pinctrl-0 = <&enet_phy_pins>;
+		compatible = "ethernet-phy-ieee802.3-c22";
+		reg = <0>;
+		interrupt-parent = <&gpio2>;
+		interrupts = <26 IRQ_TYPE_LEVEL_LOW>;	/* gpio_58 */
+	};
 };
 
 &dss {
@@ -257,6 +270,12 @@ OMAP3_CORE1_IOPAD(0x2210, PIN_INPUT_PULLDOWN | MUX_MODE0) /* rmii_50mhz_clk */
 		>;
 	};
 
+	enet_phy_pins: pinmux_ent_phy_pins {
+		pinctrl-single,pins = <
+			OMAP3_CORE1_IOPAD(0x20bc, PIN_INPUT | MUX_MODE4)	/* gpmc_ncs7.gpio_57 */
+		>;
+	};
+
 	i2c2_pins: i2c2-pins {
 		pinctrl-single,pins = <
 			OMAP3_CORE1_IOPAD(0x21be, PIN_INPUT_PULLUP | MUX_MODE0)  /* i2c2_scl */
-- 
2.39.2