[PATCH 1/2] pm80xx: Use phy specific sas address when sending PHY_START command

[Michal Grzedzicki]

Some cards have more than one sas addresses. Using incorrect
address causes communication issues with some devices like expanders.

Signed-off-by: Michal Grzedzicki <mge@xxxxxxxx>
---
 drivers/scsi/pm8001/pm8001_hwi.c | 2 +-
 drivers/scsi/pm8001/pm80xx_hwi.c | 2 +-
 2 files changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/scsi/pm8001/pm8001_hwi.c b/drivers/scsi/pm8001/pm8001_hwi.c
index 33053db5a713..90069c7b1642 100644
--- a/drivers/scsi/pm8001/pm8001_hwi.c
+++ b/drivers/scsi/pm8001/pm8001_hwi.c
@@ -4180,7 +4180,7 @@ pm8001_chip_phy_start_req(struct pm8001_hba_info *pm8001_ha, u8 phy_id)
 	payload.sas_identify.dev_type = SAS_END_DEVICE;
 	payload.sas_identify.initiator_bits = SAS_PROTOCOL_ALL;
 	memcpy(payload.sas_identify.sas_addr,
-		pm8001_ha->sas_addr, SAS_ADDR_SIZE);
+		&pm8001_ha->phy[phy_id].dev_sas_addr, SAS_ADDR_SIZE);
 	payload.sas_identify.phy_id = phy_id;
 
 	return pm8001_mpi_build_cmd(pm8001_ha, 0, opcode, &payload,
diff --git a/drivers/scsi/pm8001/pm80xx_hwi.c b/drivers/scsi/pm8001/pm80xx_hwi.c
index f6857632dc7c..1b2c40b1381c 100644
--- a/drivers/scsi/pm8001/pm80xx_hwi.c
+++ b/drivers/scsi/pm8001/pm80xx_hwi.c
@@ -4671,7 +4671,7 @@ pm80xx_chip_phy_start_req(struct pm8001_hba_info *pm8001_ha, u8 phy_id)
 	payload.sas_identify.dev_type = SAS_END_DEVICE;
 	payload.sas_identify.initiator_bits = SAS_PROTOCOL_ALL;
 	memcpy(payload.sas_identify.sas_addr,
-	  &pm8001_ha->sas_addr, SAS_ADDR_SIZE);
+		&pm8001_ha->phy[phy_id].dev_sas_addr, SAS_ADDR_SIZE);
 	payload.sas_identify.phy_id = phy_id;
 
 	return pm8001_mpi_build_cmd(pm8001_ha, 0, opcode, &payload,
-- 
2.34.1