Re: [PATCH v1 03/11] leds: aw200xx: support HWEN hardware control
From: Andy Shevchenko
Date: Fri Oct 06 2023 - 13:58:06 EST
On Fri, Oct 6, 2023 at 7:04 PM Dmitry Rokosov
<ddrokosov@xxxxxxxxxxxxxxxxx> wrote:
>
> HWEN is hardware control, which is used for enable/disable aw200xx chip.
> It's high active, internally pulled down to GND.
>
> After HWEN pin set high the chip begins to load the OTP information,
> which takes 200us to complete. About 200us wait time is needed for
> internal oscillator startup and display SRAM initialization. After
> display SRAM initialization, the registers in page1 to page5 can be
pages 1 to 5
> configured via i2c interface.
...
> +#include <linux/of_gpio.h>
Definitely not.
Use agnostic APIs.
...
> @@ -116,6 +117,7 @@ struct aw200xx {
> struct mutex mutex;
> u32 num_leds;
> u32 display_rows;
> + int hwen;
> struct aw200xx_led leds[];
Side note: add a patch to use __counted_by() here.
> };
...
> + if (!gpio_is_valid(chip->hwen))
Absolutely not. You may not use legacy GPIO APIs.
> + return;
> +
> + gpio_set_value(chip->hwen, 1);
Ditto.
...
> + usleep_range(400, 500);
fsleep() ?
...
> +static void aw200xx_disable(const struct aw200xx *const chip)
> +{
> + if (gpio_is_valid(chip->hwen))
> + gpio_set_value(chip->hwen, 0);
> +}
As per above.
...
> +static void aw200xx_probe_hwen(struct device *dev, struct aw200xx *chip)
> +{
> + chip->hwen = of_get_named_gpio(dev->of_node, "awinic,hwen-gpio", 0);
> + if (gpio_is_valid(chip->hwen))
> + if (devm_gpio_request_one(dev, chip->hwen, GPIOF_OUT_INIT_HIGH,
> + "AW200XX HWEN")) {
> + dev_warn(dev, "Can't request gpio %d, tag it invalid\n",
> + chip->hwen);
> + chip->hwen = -EINVAL;
> + }
> +}
Please, rewrite this completely using supported APIs and not
deprecated or obsolete ones.
--
With Best Regards,
Andy Shevchenko