Re: [RFC 1/2] dt-bindings: iio: imu: Add DT binding doc for BMI323

[Jagath Jog J]

Hi Jonathan,

Few more questions before sending the next series.

On Sat, Sep 30, 2023 at 9:35 PM Jonathan Cameron <jic23@xxxxxxxxxx> wrote:
>
> On Thu, 28 Sep 2023 03:07:22 +0530
> Jagath Jog J <jagathjog1996@xxxxxxxxx> wrote:
>
> > HI Jonathan,
> >
> > On Sun, Sep 24, 2023 at 7:07 PM Jonathan Cameron <jic23@xxxxxxxxxx> wrote:
> > >
> > > On Mon, 18 Sep 2023 13:33:13 +0530
> > > Jagath Jog J <jagathjog1996@xxxxxxxxx> wrote:
> > >
> > > > Add devicetree description document for Bosch BMI323, a 6-Axis IMU.
> > > >
> > > > Signed-off-by: Jagath Jog J <jagathjog1996@xxxxxxxxx>

> > > > +  interrupts:
> > > > +    maxItems: 1
> > > > +
> > > > +  interrupt-names:
> > > > +    enum:
> > > > +      - INT1
> > > > +      - INT2
> > > > +    description: |
> > > > +      set to "INT1" if INT1 pin should be used as interrupt input, set
> > > > +      to "INT2" if INT2 pin should be used instead
> > >
> > > Why not both?  Sure driver might elect to use only one, but the binding
> > > describes the hardware not the driver and both might be wired.
> >
> > If both interrupt pins are wired, should the DTS file need to define
> > both of the pins?
>
> Yes it should. + we need the names to know which is which.
> You could rely on order, but it's more flexible to not do so, particularly
> when you also need to support case where only one is wired.

In the driver, I currently prioritize INT1 over INT2 when checking
(bmi323_trigger_probe(..)) based on the interrupt-names defined
in the device tree. However, I'm open to suggestions on the best
way to ensure that the order doesn't affect the selection process
when both interrupts are defined in the device tree.

Each feature, such as data-ready, watermark, tap, and others, supports
either INT1 or INT2. Based on the interrupt pin defined in the device tree,
I configure the all the features accordingly.

Regarding your earlier suggestion to have two different controls for
drive-open-drain, do I need to define sensor-specific drive controls
in bindings for both interrupt pins?
for ex: bosch,irq{1,2}-open-drain

Regards
Jagath
>
>
> Jonathan
>
>