[PATCH] doc: blk-ioprio: Standardize a few names

[yizhou . tang]

From: Tang Yizhou <yizhou.tang@xxxxxxxxxx>

Our system administrator have noted that the names 'rt-to-be' and
'all-to-idle' in the I/O priority policies table appeared without
explanations, leading to confusion. Let's standardize these names in
line with the naming in the 'attribute' section.

Additionally,
1. Correct the interface name to 'io.prio.class'.
2. Add a table entry of 'promote-to-rt' for consistency.
3. Fix a typo of 'priority'.

Suggested-by: Yingfu Zhou <yingfu.zhou@xxxxxxxxxx>
Signed-off-by: Tang Yizhou <yizhou.tang@xxxxxxxxxx>
---
 Documentation/admin-guide/cgroup-v2.rst | 10 ++++++----
 1 file changed, 6 insertions(+), 4 deletions(-)

diff --git a/Documentation/admin-guide/cgroup-v2.rst b/Documentation/admin-guide/cgroup-v2.rst
index 4ef890191196..10461c73c9a3 100644
--- a/Documentation/admin-guide/cgroup-v2.rst
+++ b/Documentation/admin-guide/cgroup-v2.rst
@@ -2023,7 +2023,7 @@ IO Priority
 ~~~~~~~~~~~
 
 A single attribute controls the behavior of the I/O priority cgroup policy,
-namely the blkio.prio.class attribute. The following values are accepted for
+namely the io.prio.class attribute. The following values are accepted for
 that attribute:
 
   no-change
@@ -2052,9 +2052,11 @@ The following numerical values are associated with the I/O priority policies:
 +----------------+---+
 | no-change      | 0 |
 +----------------+---+
-| rt-to-be       | 2 |
+| promote-to-rt  | 1 |
 +----------------+---+
-| all-to-idle    | 3 |
+| restrict-to-be | 2 |
++----------------+---+
+| idle           | 3 |
 +----------------+---+
 
 The numerical value that corresponds to each I/O priority class is as follows:
@@ -2074,7 +2076,7 @@ The algorithm to set the I/O priority class for a request is as follows:
 - If I/O priority class policy is promote-to-rt, change the request I/O
   priority class to IOPRIO_CLASS_RT and change the request I/O priority
   level to 4.
-- If I/O priorityt class is not promote-to-rt, translate the I/O priority
+- If I/O priority class policy is not promote-to-rt, translate the I/O priority
   class policy into a number, then change the request I/O priority class
   into the maximum of the I/O priority class policy number and the numerical
   I/O priority class.
-- 
2.25.1