Re: [PATCH v9 4/4] clk: qcom: add clock controller driver for qca8386/qca8084

[Bryan O'Donoghue]

On 23/09/2023 12:21, Luo Jie wrote:
> The clock controller driver of qca8386/qca8084 is registered
> as the MDIO device, the hardware register is accessed by MDIO bus
> that is normally used to access general PHY device, which is
> different from the current existed qcom clock controller drivers
> using ioremap to access hardware clock registers.

"nsscc-qca8k is accessed via an MDIO bus"

> MDIO bus is common utilized by both qca8386/qca8084 and other

commonly

> PHY devices, so the mutex lock mdio_bus->mdio_lock should be
> used instead of using the mutex lock of remap.
>
> To access the hardware clock registers of qca8386/qca8084, there
> is special MDIO frame sequence(three MDIO read/write operations)
> need to be sent to device.

"there is a special MDIO frame sequence"

"which needs to be sent to the device"

the following indentation splat from checkpatch

CHECK: Alignment should match open parenthesis
#2071: FILE: drivers/clk/qcom/nsscc-qca8k.c:2004:
+		ret = __mdiobus_write(bus, switch_phy_id, (reg | 
QCA8K_REG_DATA_UPPER_16_BITS),
+				upper_16_bits(val));

CHECK: Alignment should match open parenthesis
#2131: FILE: drivers/clk/qcom/nsscc-qca8k.c:2064:
+static int qca8k_regmap_update_bits(void *context, unsigned int regaddr,
+		unsigned int mask, unsigned int value)

total: 0 errors, 1 warnings, 2 checks, 2162 lines checked

NOTE: For some of the reported defects, checkpatch may be able to
      mechanically convert to the typical style using --fix or 
--fix-inplace.

0004-clk-qcom-add-clock-controller-driver-for-qca8386-qca.patch has 
style problems, please review.

Once fixed

Reviewed-by: Bryan O'Donoghue <bryan.odonoghue@xxxxxxxxxx>