[v2] xhci: Keep interrupt disabled in initialization until host is running.

[Prashanth K]

From: Hongyu Xie <xy521521@xxxxxxxxx>

[ Upstream commit a808925075fb750804a60ff0710614466c396db4 ]

irq is disabled in xhci_quiesce(called by xhci_halt, with bit:2 cleared
in USBCMD register), but xhci_run(called by usb_add_hcd) re-enable it.
It's possible that you will receive thousands of interrupt requests
after initialization for 2.0 roothub. And you will get a lot of
warning like, "xHCI dying, ignoring interrupt. Shouldn't IRQs be
disabled?". This amount of interrupt requests will cause the entire
system to freeze.
This problem was first found on a device with ASM2142 host controller
on it.

[tidy up old code while moving it, reword header -Mathias]

Cc: stable@xxxxxxxxxx
Signed-off-by: Hongyu Xie <xiehongyu1@xxxxxxxxxx>
Signed-off-by: Mathias Nyman <mathias.nyman@xxxxxxxxxxxxxxx>
Link: https://lore.kernel.org/r/20220623111945.1557702-2-mathias.nyman@xxxxxxxxxxxxxxx
Signed-off-by: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx>
Cc: <stable@xxxxxxxxxxxxxxx> # 5.15
Signed-off-by: Prashanth K <quic_prashk@xxxxxxxxxxx>
---
v2: Added a missing newline to avoid merge conflicts in future.

 drivers/usb/host/xhci.c | 35 ++++++++++++++++++++++-------------
 1 file changed, 22 insertions(+), 13 deletions(-)

diff --git a/drivers/usb/host/xhci.c b/drivers/usb/host/xhci.c
index 541fe4d..0803f9b 100644
--- a/drivers/usb/host/xhci.c
+++ b/drivers/usb/host/xhci.c
@@ -607,8 +607,27 @@ static int xhci_init(struct usb_hcd *hcd)
 
 static int xhci_run_finished(struct xhci_hcd *xhci)
 {
+	unsigned long	flags;
+	u32		temp;
+
+	/*
+	 * Enable interrupts before starting the host (xhci 4.2 and 5.5.2).
+	 * Protect the short window before host is running with a lock
+	 */
+	spin_lock_irqsave(&xhci->lock, flags);
+
+	xhci_dbg_trace(xhci, trace_xhci_dbg_init, "Enable interrupts");
+	temp = readl(&xhci->op_regs->command);
+	temp |= (CMD_EIE);
+	writel(temp, &xhci->op_regs->command);
+
+	xhci_dbg_trace(xhci, trace_xhci_dbg_init, "Enable primary interrupter");
+	temp = readl(&xhci->ir_set->irq_pending);
+	writel(ER_IRQ_ENABLE(temp), &xhci->ir_set->irq_pending);
+
 	if (xhci_start(xhci)) {
 		xhci_halt(xhci);
+		spin_unlock_irqrestore(&xhci->lock, flags);
 		return -ENODEV;
 	}
 	xhci->shared_hcd->state = HC_STATE_RUNNING;
@@ -619,6 +638,9 @@ static int xhci_run_finished(struct xhci_hcd *xhci)
 
 	xhci_dbg_trace(xhci, trace_xhci_dbg_init,
 			"Finished xhci_run for USB3 roothub");
+
+	spin_unlock_irqrestore(&xhci->lock, flags);
+
 	return 0;
 }
 
@@ -667,19 +689,6 @@ int xhci_run(struct usb_hcd *hcd)
 	temp |= (xhci->imod_interval / 250) & ER_IRQ_INTERVAL_MASK;
 	writel(temp, &xhci->ir_set->irq_control);
 
-	/* Set the HCD state before we enable the irqs */
-	temp = readl(&xhci->op_regs->command);
-	temp |= (CMD_EIE);
-	xhci_dbg_trace(xhci, trace_xhci_dbg_init,
-			"// Enable interrupts, cmd = 0x%x.", temp);
-	writel(temp, &xhci->op_regs->command);
-
-	temp = readl(&xhci->ir_set->irq_pending);
-	xhci_dbg_trace(xhci, trace_xhci_dbg_init,
-			"// Enabling event ring interrupter %p by writing 0x%x to irq_pending",
-			xhci->ir_set, (unsigned int) ER_IRQ_ENABLE(temp));
-	writel(ER_IRQ_ENABLE(temp), &xhci->ir_set->irq_pending);
-
 	if (xhci->quirks & XHCI_NEC_HOST) {
 		struct xhci_command *command;
 
-- 
2.7.4