On Tue, 17 Oct 2023, kenechukwu maduechesi wrote:
Replace udelay() with usleep_range() for more precise delay handling.
Reported by checkpatch:
CHECK: usleep_range is preferred over udelay
This message is typically not a good candidate for outreachy patches,
because you need access to the device to be sure that any change is
correct.
julia
Signed-off-by: kenechukwu maduechesi <maduechesik@xxxxxxxxx>
---
drivers/staging/rts5208/sd.c | 10 +++++-----
1 file changed, 5 insertions(+), 5 deletions(-)
diff --git a/drivers/staging/rts5208/sd.c b/drivers/staging/rts5208/sd.c
index 74c4f476b3a4..059f99b0a727 100644
--- a/drivers/staging/rts5208/sd.c
+++ b/drivers/staging/rts5208/sd.c
@@ -865,7 +865,7 @@ static int sd_change_phase(struct rtsx_chip *chip, u8 sample_point, u8 tune_dir)
PHASE_CHANGE);
if (retval)
return retval;
- udelay(50);
+ usleep_range(50);
retval = rtsx_write_register(chip, SD_VP_CTL, 0xFF,
PHASE_CHANGE |
PHASE_NOT_RESET |
@@ -877,14 +877,14 @@ static int sd_change_phase(struct rtsx_chip *chip, u8 sample_point, u8 tune_dir)
CHANGE_CLK, CHANGE_CLK);
if (retval)
return retval;
- udelay(50);
+ usleep_range(50);
retval = rtsx_write_register(chip, SD_VP_CTL, 0xFF,
PHASE_NOT_RESET |
sample_point);
if (retval)
return retval;
}
- udelay(100);
+ usleep_range(100);
rtsx_init_cmd(chip);
rtsx_add_cmd(chip, WRITE_REG_CMD, SD_DCMPS_CTL, DCMPS_CHANGE,
@@ -918,7 +918,7 @@ static int sd_change_phase(struct rtsx_chip *chip, u8 sample_point, u8 tune_dir)
return retval;
}
- udelay(50);
+ usleep_range(50);
}
retval = rtsx_write_register(chip, SD_CFG1, SD_ASYNC_FIFO_NOT_RST, 0);
@@ -1416,7 +1416,7 @@ static int sd_wait_data_idle(struct rtsx_chip *chip)
retval = STATUS_SUCCESS;
break;
}
- udelay(100);
+ usleep_range(100);
}
dev_dbg(rtsx_dev(chip), "SD_DATA_STATE: 0x%02x\n", val);
--
2.25.1