[PATCH v3 0/3] iio: imu: adis: Use spi cs inactive delay

[Ramona Gradinariu]

A delay is needed each time the chip selected becomes inactive,
even after burst data readings are performed.
Currently, there is no delay added after a burst reading
and in case a new SPI transfer is performed before
the needed delay, the adis device becomes unresponsive until
reset.

This commit is adding the needed delay directly to the spi driver,
using the cs_inactive parameter, in case it is not set and is
removing the additional chip select change delay present in adis
APIs to remove the double delay.

Ramona Gradinariu (3):
  iio: imu: adis: Use spi cs inactive delay
  dt-bindings: adis16475: Add 'spi-cs-inactive-delay-ns' property
  dt-bindings: adis16460: Add 'spi-cs-inactive-delay-ns' property

 .../bindings/iio/imu/adi,adis16460.yaml        |  4 ++++
 .../bindings/iio/imu/adi,adis16475.yaml        |  4 ++++
 drivers/iio/imu/adis.c                         | 18 ++++++------------
 3 files changed, 14 insertions(+), 12 deletions(-)

--
2.34.1