Re: [PATCH v2 2/7] scsi: ufs: ufs-qcom: Setup host power mode during init

[Can Guo]

Hi Andrew,

On 11/8/2023 4:14 AM, Andrew Halaney wrote:
> On Mon, Nov 06, 2023 at 08:46:08PM -0800, Can Guo wrote:
> > From: Can Guo <quic_cang@xxxxxxxxxxx>
> >
> > Setup host power mode and its limitations during UFS host driver init to
> > avoid repetitive work during every power mode change.
> >
> > Co-developed-by: Bao D. Nguyen <quic_nguyenb@xxxxxxxxxxx>
> > Signed-off-by: Bao D. Nguyen <quic_nguyenb@xxxxxxxxxxx>
> > Signed-off-by: Can Guo <quic_cang@xxxxxxxxxxx>
> > ---
> >   drivers/ufs/host/ufs-qcom.c | 22 ++++++++++++++--------
> >   drivers/ufs/host/ufs-qcom.h |  1 +
> >   2 files changed, 15 insertions(+), 8 deletions(-)
> >
> > diff --git a/drivers/ufs/host/ufs-qcom.c b/drivers/ufs/host/ufs-qcom.c
> > index aee66a3..cc0eb37 100644
> > --- a/drivers/ufs/host/ufs-qcom.c
> > +++ b/drivers/ufs/host/ufs-qcom.c
> > @@ -898,7 +898,7 @@ static int ufs_qcom_pwr_change_notify(struct ufs_hba *hba,
> >   				struct ufs_pa_layer_attr *dev_req_params)
> >   {
> >   	struct ufs_qcom_host *host = ufshcd_get_variant(hba);
> > -	struct ufs_host_params host_params;
> > +	struct ufs_host_params *host_params = &host->host_params;
> >   	int ret = 0;
> >   
> >   	if (!dev_req_params) {
> > @@ -908,13 +908,7 @@ static int ufs_qcom_pwr_change_notify(struct ufs_hba *hba,
> >   
> >   	switch (status) {
> >   	case PRE_CHANGE:
> > -		ufshcd_init_host_param(&host_params);
> > -		host_params.hs_rate = UFS_QCOM_LIMIT_HS_RATE;
> You drop the setting of hs_rate in your new function. It seems setting that's
> also overkill since UFS_QCOM_LIMIT_HS_RATE == PA_HS_MODE_B. hs_rate is
> already set to that in ufshcd_init_host_param(), so removing it makes
> sense.
>
> Can you remove it prior in its own patch, and remove the now unused
> UFS_QCOM_LIMIT_HS_RATE as well from ufs-qcom.h?

Sure, will address this in next version.

> With that in place this seems like a good improvement:
>
> Acked-by: Andrew Halaney <ahalaney@xxxxxxxxxx>


Thanks,

Can Guo.