Re: [PATCH 5/6] mtd: rawnand: gpio: Support standard nand width

[Miquel Raynal]

Hi Linus,

linus.walleij@xxxxxxxxxx wrote on Wed, 08 Nov 2023 15:33:53 +0100:

> The standard property for describing the band width of a NAND
> memory is "nand-bus-width" not "bank-width". The new bindings
> support both so make Linux check both in priority order.
> 
> Signed-off-by: Linus Walleij <linus.walleij@xxxxxxxxxx>
> ---
>  drivers/mtd/nand/raw/gpio.c | 10 +++++++++-
>  1 file changed, 9 insertions(+), 1 deletion(-)
> 
> diff --git a/drivers/mtd/nand/raw/gpio.c b/drivers/mtd/nand/raw/gpio.c
> index 5553101c709c..d5bd245b0c0d 100644
> --- a/drivers/mtd/nand/raw/gpio.c
> +++ b/drivers/mtd/nand/raw/gpio.c
> @@ -183,7 +183,15 @@ static int gpio_nand_get_config(struct device *dev,
>  {
>  	u32 val;
>  
> -	if (!device_property_read_u32(dev, "bank-width", &val)) {
> +	/* The preferred binding takes precedence */
> +	if (!device_property_read_u32(dev, "nand-bus-width", &val)) {
> +		if (val == 16) {
> +			chip->options |= NAND_BUSWIDTH_16;
> +		} else if (val != 8) {
> +			dev_err(dev, "invalid nand-bus-width %u\n", val);
> +			return -EINVAL;
> +		}
> +	} else if (!device_property_read_u32(dev, "bank-width", &val)) {
>  		if (val == 2) {
>  			chip->options |= NAND_BUSWIDTH_16;
>  		} else if (val != 1) {
> 

I'm not sure this is actually needed. I believe of_get_nand_bus_width
is already called (nand_scan_ident -> rawnand_dt_init) and will set the
NAND_BUSWIDTH_16 flag automatically. So the above 'if' is already a
fallback. Maybe you can add a comment if you want to make this more
explicit that the real property is nand-bus-width and the property
parsed in the driver is for backward compatibility only?

Thanks,
Miquèl