Re: [PATCH V2] mmc: sprd: Fix vqmmc not shutting down after the card was pulled

[Ulf Hansson]

On Wed, 15 Nov 2023 at 09:34, Wenchao Chen <wenchao.chen@xxxxxxxxxx> wrote:
>
> With cat regulator_summary, we found that vqmmc was not shutting
> down after the card was pulled.
>
> cat /sys/kernel/debug/regulator/regulator_summary
> 1.before fix
> 1)Insert SD card
>  vddsdio                1    1  0 unknown  3500mV 0mA  1200mV  3750mV
>     71100000.mmc-vqmmc  1                         0mA  3500mV  3600mV
>
> 2)Pull out the SD card
>  vddsdio                1    1  0 unknown  3500mV 0mA  1200mV  3750mV
>     71100000.mmc-vqmmc  1                         0mA  3500mV  3600mV
>
> 2.after fix
> 1)Insert SD cardt
>  vddsdio                1    1  0 unknown  3500mV 0mA  1200mV  3750mV
>     71100000.mmc-vqmmc  1                         0mA  3500mV  3600mV
>
> 2)Pull out the SD card
>  vddsdio                0    1  0 unknown  3500mV 0mA  1200mV  3750mV
>     71100000.mmc-vqmmc  0                         0mA  3500mV  3600mV
>
> Fixes: fb8bd90f83c4 ("mmc: sdhci-sprd: Add Spreadtrum's initial host controller")
> Signed-off-by: Wenchao Chen <wenchao.chen@xxxxxxxxxx>

Applied for fixes and by adding a stable tag, thanks!

Kind regards
Uffe


>
> Change in v2:
> - Remove useless sdhci_sprd_signal_voltage_switch and power_mode.
> - Use mmc_regulator_get_supply in probe to prevent sdhci_setup_host
>   from powering up vqmmc.
> ---
>  drivers/mmc/host/sdhci-sprd.c | 25 +++++++++++++++++++++++++
>  1 file changed, 25 insertions(+)
>
> diff --git a/drivers/mmc/host/sdhci-sprd.c b/drivers/mmc/host/sdhci-sprd.c
> index 6b84ba27e6ab..6b8a57e2d20f 100644
> --- a/drivers/mmc/host/sdhci-sprd.c
> +++ b/drivers/mmc/host/sdhci-sprd.c
> @@ -416,12 +416,33 @@ static void sdhci_sprd_request_done(struct sdhci_host *host,
>         mmc_request_done(host->mmc, mrq);
>  }
>
> +static void sdhci_sprd_set_power(struct sdhci_host *host, unsigned char mode,
> +                                unsigned short vdd)
> +{
> +       struct mmc_host *mmc = host->mmc;
> +
> +       switch (mode) {
> +       case MMC_POWER_OFF:
> +               mmc_regulator_set_ocr(host->mmc, mmc->supply.vmmc, 0);
> +
> +               mmc_regulator_disable_vqmmc(mmc);
> +               break;
> +       case MMC_POWER_ON:
> +               mmc_regulator_enable_vqmmc(mmc);
> +               break;
> +       case MMC_POWER_UP:
> +               mmc_regulator_set_ocr(host->mmc, mmc->supply.vmmc, vdd);
> +               break;
> +       }
> +}
> +
>  static struct sdhci_ops sdhci_sprd_ops = {
>         .read_l = sdhci_sprd_readl,
>         .write_l = sdhci_sprd_writel,
>         .write_w = sdhci_sprd_writew,
>         .write_b = sdhci_sprd_writeb,
>         .set_clock = sdhci_sprd_set_clock,
> +       .set_power = sdhci_sprd_set_power,
>         .get_max_clock = sdhci_sprd_get_max_clock,
>         .get_min_clock = sdhci_sprd_get_min_clock,
>         .set_bus_width = sdhci_set_bus_width,
> @@ -823,6 +844,10 @@ static int sdhci_sprd_probe(struct platform_device *pdev)
>         host->caps1 &= ~(SDHCI_SUPPORT_SDR50 | SDHCI_SUPPORT_SDR104 |
>                          SDHCI_SUPPORT_DDR50);
>
> +       ret = mmc_regulator_get_supply(host->mmc);
> +       if (ret)
> +               goto pm_runtime_disable;
> +
>         ret = sdhci_setup_host(host);
>         if (ret)
>                 goto pm_runtime_disable;
> --
> 2.17.1
>