Re: [PATCH v6 3/6] net: phy: at803x: add QCA8084 ethernet phy support
From: Jie Luo
Date: Wed Nov 29 2023 - 05:34:41 EST
On 11/28/2023 6:35 PM, Russell King (Oracle) wrote:
On Tue, Nov 28, 2023 at 05:50:41PM +0800, Jie Luo wrote:
On 11/28/2023 5:00 PM, Russell King (Oracle) wrote:
On Tue, Nov 28, 2023 at 03:16:45PM +0800, Jie Luo wrote:
The interface mode is passed in the .config_init, which is configured
by the PCS driver, the hardware register is located in the PCS, this
driver will be pushed later.
Is this the same as how the syqca807x works? Can the PCS driver be
shared by these two drivers?
I am not sure syqca807x, would you point me the code path of this driver?
What i don't like at the moment is that we have two driver
developments going on at once for hardware which seems very similar,
but no apparent cooperation?
Andrew
The PCS of qca8084 is the PHY PCS, which should be new PCS driver,
in the previous chips, we don't have this kind of PHY PCS.
No. PCS drivers are for MAC-side PCS drivers, not PHY-side PCS drivers.
+-------------
| PHY
MAC---PCS --- link --- PCS --- ...
^ | ^
| +--|----------
For this PCS |
Not for this PCS
The PCS drivers in drivers/net/pcs/ should be in PHY side, such as
pcs-lynx.c and pcs-xpcs.c, they are configuring the MDIO device
registers.
Wrong. No they are not. Just because they are accessed via MDIO does
not mean they are in the PHY. MDIO can be used for more than just the
PHY, and is on a lot of platforms.
LX2160A for example has many MDIO buses, and the PCSes (of which there
are multiple inside the chip, and use pcs-lynx) are accessed through
the MDIO bus specific to each port. They are not MMIO mapped.
The same is true on stmmac platforms, where xpcs is used - xpcs is the
_MAC_ side PCS.
Sorry but you are wrong.
OK, but it creates the PCS driver based on the MDIO device in pcs-lynx.c
looks like this PCS is located in PHY device from hardware perspective.