[PATCH] x86/sev: Do the C-bit verification only on the BSP

[Borislav Petkov]

From: "Borislav Petkov (AMD)" <bp@xxxxxxxxx>

There's no need to do it on every AP.

The C-bit value read on the BSP and also verified there, is used
everywhere from now on.

There should be no functional changes resulting from this patch - just
a bit faster booting APs.

Signed-off-by: Borislav Petkov (AMD) <bp@xxxxxxxxx>
---
 arch/x86/kernel/head_64.S | 31 ++++++++++++++++++++++---------
 1 file changed, 22 insertions(+), 9 deletions(-)

diff --git a/arch/x86/kernel/head_64.S b/arch/x86/kernel/head_64.S
index 3dcabbc49149..af40d8eb4dca 100644
--- a/arch/x86/kernel/head_64.S
+++ b/arch/x86/kernel/head_64.S
@@ -114,6 +114,28 @@ SYM_CODE_START_NOALIGN(startup_64)
 
 	/* Form the CR3 value being sure to include the CR3 modifier */
 	addq	$(early_top_pgt - __START_KERNEL_map), %rax
+
+#ifdef CONFIG_AMD_MEM_ENCRYPT
+	mov	%rax, %rdi
+	mov	%rax, %r14
+
+	addq	phys_base(%rip), %rdi
+
+	/*
+	 * For SEV guests: Verify that the C-bit is correct. A malicious
+	 * hypervisor could lie about the C-bit position to perform a ROP
+	 * attack on the guest by writing to the unencrypted stack and wait for
+	 * the next RET instruction.
+	 */
+	call	sev_verify_cbit
+
+	/*
+	 * Restore CR3 value without the phys_base which will be added
+	 * below, before writing %cr3.
+	 */
+	 mov	%r14, %rax
+#endif
+
 	jmp 1f
 SYM_CODE_END(startup_64)
 
@@ -192,15 +214,6 @@ SYM_INNER_LABEL(secondary_startup_64_no_verify, SYM_L_GLOBAL)
 	/* Setup early boot stage 4-/5-level pagetables. */
 	addq	phys_base(%rip), %rax
 
-	/*
-	 * For SEV guests: Verify that the C-bit is correct. A malicious
-	 * hypervisor could lie about the C-bit position to perform a ROP
-	 * attack on the guest by writing to the unencrypted stack and wait for
-	 * the next RET instruction.
-	 */
-	movq	%rax, %rdi
-	call	sev_verify_cbit
-
 	/*
 	 * Switch to new page-table
 	 *
-- 
2.42.0.rc0.25.ga82fb66fed25