Re: [PATCH v3 03/13] iio: adc: ad7091r: Set alert bit in config register

[Jonathan Cameron]

On Thu, 7 Dec 2023 15:38:53 -0300
Marcelo Schmitt <marcelo.schmitt@xxxxxxxxxx> wrote:

> The ad7091r-base driver sets up an interrupt handler for firing events
> when inputs are either above or below a certain threshold.
> However, for the interrupt signal to come from the device it must be
> configured to enable the ALERT/BUSY/GPO pin to be used as ALERT, which
> was not being done until now.
> Enable interrupt signals on the ALERT/BUSY/GPO pin by setting the proper
> bit in the configuration register.
> 
> Signed-off-by: Marcelo Schmitt <marcelo.schmitt@xxxxxxxxxx>
Also a fix?  Feels like people expect this to work but I guess we could
in theory call it a 'feature' given it never did :)

Jonathan

> ---
>  drivers/iio/adc/ad7091r-base.c | 6 ++++++
>  1 file changed, 6 insertions(+)
> 
> diff --git a/drivers/iio/adc/ad7091r-base.c b/drivers/iio/adc/ad7091r-base.c
> index 0f192fbecbd4..6056a66d756c 100644
> --- a/drivers/iio/adc/ad7091r-base.c
> +++ b/drivers/iio/adc/ad7091r-base.c
> @@ -28,6 +28,7 @@
>  #define AD7091R_REG_RESULT_CONV_RESULT(x)   ((x) & 0xfff)
>  
>  /* AD7091R_REG_CONF */
> +#define AD7091R_REG_CONF_ALERT_EN   BIT(4)
>  #define AD7091R_REG_CONF_AUTO   BIT(8)
>  #define AD7091R_REG_CONF_CMD    BIT(10)
>  
> @@ -232,6 +233,11 @@ int ad7091r_probe(struct device *dev, const char *name,
>  	iio_dev->channels = chip_info->channels;
>  
>  	if (irq) {
> +		ret = regmap_update_bits(st->map, AD7091R_REG_CONF,
> +					 AD7091R_REG_CONF_ALERT_EN, BIT(4));
> +		if (ret)
> +			return ret;
> +
>  		dev_set_drvdata(st->dev, iio_dev);
>  		ret = devm_request_threaded_irq(dev, irq, NULL,
>  				ad7091r_event_handler,