Re: [RFC PATCH] tty: serial: kgdboc: Fix 8250_* kgd over serial

[Michael Nazzareno Trimarchi]

Hi Doug

On Mon, Dec 11, 2023 at 11:00 PM Doug Anderson <dianders@xxxxxxxxxxxx> wrote:
>
> Hi,
>
> On Mon, Dec 11, 2023 at 1:42 PM Michael Nazzareno Trimarchi
> <michael@xxxxxxxxxxxxxxxxxxxx> wrote:
> >
> > > 1. init_kgdboc() runs and registers the singleton kgdb "platform driver".
> > >
> > > 2. The platform driver's probe function, kgdboc_probe(), runs and
> > > checks to see if the console is ready by looking at the return value
> > > of configure_kgdboc(). If it's ready then we're good to go. If it's
> > > not ready then we defer.
> > >
> > > So I think the bug here is that somehow the console looks "ready"
> > > (because tty_find_polling_driver() can find it) but it isn't actually
> > > ready yet (because it crashes). That's what you need to fix.
> > >
> >
> > The polling driver look for uart and uart8250_core is registered and 4 fake uart
> > are there but there are not still replaced by platform driver that can
> > come later.
> > The try_polling find it but it's the isa-8250 driver. It means that
> > add_uart 8250 is
> > not still happen
>
> The 8250 driver is always a maze, so you might need to do a bunch of
> digging. ...but it sure sounds like the console shouldn't be
> registered until the correct ops are in place. That either means
> getting the ops put in place earlier or deferring when the console is
> registered...
>

Your point is pretty clear and my initial idea was to find a real fix.
This come to avoid
breaking existing setup but anyway I will dig in it more

Michael

> -Doug



-- 
Michael Nazzareno Trimarchi
Co-Founder & Chief Executive Officer
M. +39 347 913 2170
michael@xxxxxxxxxxxxxxxxxxxx
__________________________________

Amarula Solutions BV
Joop Geesinkweg 125, 1114 AB, Amsterdam, NL
T. +31 (0)85 111 9172
info@xxxxxxxxxxxxxxxxxxxx
www.amarulasolutions.com