Re: [PATCH v8 13/14] net: phy: at803x: configure qca8084 work mode

[Jie Luo]

On 12/17/2023 9:02 PM, Simon Horman wrote:
> On Fri, Dec 15, 2023 at 03:40:03PM +0800, Luo Jie wrote:
>
> ...
>
> > @@ -1038,6 +1045,46 @@ static int qca8084_common_clock_init(struct phy_device *phydev)
> >   	return clk_prepare_enable(priv->clk[MDIO_MASTER_AHB_CLK]);
> >   }
> >   
> > +static int qca8084_parse_and_set_work_mode(struct phy_device *phydev)
> > +{
> > +	struct device_node *node;
> > +	struct at803x_priv *priv;
> > +	u32 value, work_mode;
> > +	int ret;
> > +
> > +	node = phydev->mdio.dev.of_node;
> > +	priv = phydev->priv;
>
> Hi Luo Jie,
>
> a minor nit from my side: priv is set but otherwise unused in this function.

Thanks Simon, i will update it to remove it.

> > +
> > +	/* The property "qcom,phy-work-mode" is only defined in one
> > +	 * PHY device tree node.
> > +	 */
> > +	ret = of_property_read_u32(node, "qcom,phy-work-mode", &value);
> > +	if (ret)
> > +		return ret == -EINVAL ? 0 : ret;
> > +
> > +	switch (value) {
> > +	case 0:
> > +		work_mode = QCA8084_WORK_MODE_QXGMII;
> > +		break;
> > +	case 1:
> > +		work_mode = QCA8084_WORK_MODE_QXGMII_PORT4_SGMII;
> > +		break;
> > +	case 2:
> > +		work_mode = QCA8084_WORK_MODE_SWITCH;
> > +		break;
> > +	case 3:
> > +		work_mode = QCA8084_WORK_MODE_SWITCH_PORT4_SGMII;
> > +		break;
> > +	default:
> > +		phydev_err(phydev, "invalid qcom,phy-work-mode %d\n", value);
> > +		return -EINVAL;
> > +	}
> > +
> > +	return qca8084_mii_modify(phydev, QCA8084_WORK_MODE_CFG,
> > +				  QCA8084_WORK_MODE_MASK,
> > +				  FIELD_PREP(QCA8084_WORK_MODE_MASK, work_mode));
> > +}
>
> ...