Re: [PATCH] net: phy: marvell-88q2xxx: add driver for the Marvell 88Q2220 PHY

[Dimitri Fedrau]

Am Tue, Dec 19, 2023 at 10:19:41AM +0100 schrieb Stefan Eichenberger:
> On Tue, Dec 19, 2023 at 09:11:17AM +0100, Dimitri Fedrau wrote:
> 
> > I could add the init sequence for the 88Q2221 PHY. Then you could test
> > it on your side. Would this be helpful to you ? Did you already have the
> > chance to test the patch ?
> 
> Unfortunately I haven't had time to test it yet. I will try to do it on
> Thursday, otherwise sadly it will be next year.
>
Ok.

> > You are right, but I would propose to stick to the reference init
> > sequence and make sure the PHYs works with our code and then work on
> > optimizing the code. We still can remove and/or document parts of it.
> 
> I am not sure that it will be accepted by the maintainers if you use a
> lot of registers that are not documented. For this reason, keeping it to
> a minimum might increase the chances of it being accepted.
>
Ok. Will try to reduce them.

> > Are you trying with the patch I provided or your own code ? If you use
> > my patch you should wait until V3, because I found some problems with
> > it. Switching from 1000Mbit/s to 100Mbit/s in autonegotiation mode doesn't
> > work. I could fix it but the fix touches some code already upstreamed. So
> > I tried to push parts of it yesterday. I forgot to cc you, just used the
> > get_maintainer script. I will add you to the cc list. Until then you can
> > look it up here: 20231218221814.69304-2-dima.fedrau@xxxxxxxxx
> 
> I used my own code so far but I will try again with your patches. Maybe
> send this and the other patches as a whole series so that it gets clear
> why you need the changes as Andrew wrote.
> 
Ok. Will send an V3 including all patches.

> Regards,
> Stefan

Regards,
Dimitri