[PATCH 1/1] hwmon: clarify intent of fan min/max

[Ivor Wanders]

This adds a link to the hwmon sysfs attributes in the hwmon patch
submission bullet points. It also adds an explanation denoting the
intent of the fan min and max attributes.

Signed-off-by: Ivor Wanders <ivor@xxxxxxxxxxxx>
---
 Documentation/hwmon/submitting-patches.rst |  4 +++-
 Documentation/hwmon/sysfs-interface.rst    | 12 +++++++++---
 2 files changed, 12 insertions(+), 4 deletions(-)

diff --git a/Documentation/hwmon/submitting-patches.rst b/Documentation/hwmon/submitting-patches.rst
index 6482c4f13..d634c41d7 100644
--- a/Documentation/hwmon/submitting-patches.rst
+++ b/Documentation/hwmon/submitting-patches.rst
@@ -141,7 +141,9 @@ increase the chances of your change being accepted.
 
 * When deciding which sysfs attributes to support, look at the chip's
   capabilities. While we do not expect your driver to support everything the
-  chip may offer, it should at least support all limits and alarms.
+  chip may offer, it should at least support all limits and alarms. Only
+  add attributes that follow the intent of the attributes, as described in
+  Documentation/hwmon/sysfs-interface.rst.
 
 * Last but not least, please check if a driver for your chip already exists
   before starting to write a new driver. Especially for temperature sensors,
diff --git a/Documentation/hwmon/sysfs-interface.rst b/Documentation/hwmon/sysfs-interface.rst
index f76e9f8cc..72dd5e02d 100644
--- a/Documentation/hwmon/sysfs-interface.rst
+++ b/Documentation/hwmon/sysfs-interface.rst
@@ -167,13 +167,19 @@ Fans
 ****
 
 `fan[1-*]_min`
-		Fan minimum value
+		Fan minimum value, this is intended as a way to specify
+		the desired minimum speed to the device if the device
+		supports that. It is not intended for communicating
+		a constant that denotes the lowest possible fan speed.
 
 `fan[1-*]_max`
-		Fan maximum value
+		Fan maximum value, this is intended as a way to specify
+		the desired maximum speed to the device if the device
+		supports that. It is not intended for communicating
+		a constant that denotes the highest possible fan speed.
 
 `fan[1-*]_input`
-		Fan input value.
+		Fan input value, this is the fan's current speed.
 
 `fan[1-*]_div`
 		Fan divisor.
-- 
2.17.1