Re: [RFC PATCH v1] regulator: pwm-regulator: Fix continuous get_voltage for disabled PWM

[Martin Blumenstingl]

Hello Uwe,

On Fri, Dec 22, 2023 at 8:10 AM Uwe Kleine-König
<u.kleine-koenig@xxxxxxxxxxxxxx> wrote:
[...]
> Also the calculation is wrong: If a relative duty-cyle in the interval
> [91%; 0%] maps lineary to [860 mV; 1140 mV] you get 1100 mV at
>
>              1100 mV - 860 mV
>         91 + ---------------- * (0 - 91) = 13
>              1140 mV - 860 mV
>
> (If the calculations in the driver used signed multiplication and
> division, all the checks for max_uV_duty < min_uV_duty could just go
> away.)
>
> So you want
>
> +               pwm-dutycycle-range = <13 0>;
Thank you!

> (if this restriction is really necessary).
I could not find a way around this.
Without this change pwm_regulator_set_voltage() is called with req_min
860mV and req_max 1140mV.
pwm_regulator_set_voltage() will then pick the lowest possible
voltage, which then results in 860mV (exactly what I get without any
patches).

To be able to keep the original minimum voltage in .dts would be to
work on what Mark suggested where he said:
"I'd expect a change in the init_state() function, possibly one that
programs the PWM to reflect the actual hardware state"

[...]
> > -     if (pstate.enabled)
> > -             voltage = pwm_get_relative_duty_cycle(&pstate, duty_unit);
> > -     else if (max_uV_duty < min_uV_duty)
> > -             voltage = max_uV_duty;
> > -     else
> > -             voltage = min_uV_duty;
> > +     voltage = pwm_get_relative_duty_cycle(&pstate, duty_unit);
>
> I'd add here:
>
>         if (voltage < min(max_uV_duty, min_uV_duty) ||
>             voltage > max(max_uV_duty, min_uV_duty))
>                 return -ENOTRECOVERABLE;
I can do that - although I think it should be a separate change.


Best regards,
Martin