[PATCH net v2 0/1] net: ethernet: ti: am65-cpsw: Allow for MTU values

[Sanjuán García, Jorge]

The am65-cpsw-nuss driver has a fixed definition for the maximum ethernet
frame length of 1522 bytes (AM65_CPSW_MAX_PACKET_SIZE). This limits the switch
ports to only operate at a maximum MTU of 1500 bytes. When combining this CPSW
switch with a DSA switch connected to one of its ports this limitation shows up.
The extra 8 bytes the DSA subsystem adds internally to the ethernet frame
create resulting frames bigger than 1522 bytes (1518 for non VLAN + 8 for DSA
stuff) so they get dropped by the switch.

One of the issues with the the am65-cpsw-nuss driver is that the network device
max_mtu was being set to the same fixed value defined for the max total frame
length (1522 bytes). This makes the DSA subsystem believe that the MTU of the
interface can be set to 1508 bytes to make room for the extra 8 bytes of the DSA
headers. However, all packages created assuming the 1500 bytes payload get
dropped by the switch as oversized.

This series offers a solution to this problem. The max_mtu advertised on the
network device and the actual max frame size configured on the switch registers
are made consistent by letting the extra room needed for the ethernet headers
and the frame checksum (22 bytes including VLAN).

Changes in v2:
 - Just set the max_mtu to a fixed value and calculate the overheads.
 - Define the max packet size as part of the only commit of this series.

Jorge Sanjuan Garcia (1):
  net: ethernet: ti: am65-cpsw: Fix max mtu to fit ethernet frames

 drivers/net/ethernet/ti/am65-cpsw-nuss.c | 5 +++--
 1 file changed, 3 insertions(+), 2 deletions(-)

-- 
2.34.1