[PATCH for-next v4 2/2] RDMA/rxe: Remove rxe_info from rxe_set_mtu

[Li Zhijian]

commit 9ac01f434a1e ("RDMA/rxe: Extend dbg log messages to err and info")
newly added this info. But it did only show null device when
the rdma_rxe is being loaded because dev_name(rxe->ib_dev->dev)
has not yet been assigned at the moment:

"(null): rxe_set_mtu: Set mtu to 1024"

Remove it to silent this message, check the mtu from it backend link
instead if needed.

CC: Bob Pearson <rpearsonhpe@xxxxxxxxx>
Signed-off-by: Li Zhijian <lizhijian@xxxxxxxxxxx>
---
V4: Remove it rather than re-order rxe_set_mtu() and rxe_register_device()
---
 drivers/infiniband/sw/rxe/rxe.c | 2 --
 1 file changed, 2 deletions(-)

diff --git a/drivers/infiniband/sw/rxe/rxe.c b/drivers/infiniband/sw/rxe/rxe.c
index a086d588e159..ae466e72fc43 100644
--- a/drivers/infiniband/sw/rxe/rxe.c
+++ b/drivers/infiniband/sw/rxe/rxe.c
@@ -160,8 +160,6 @@ void rxe_set_mtu(struct rxe_dev *rxe, unsigned int ndev_mtu)
 
 	port->attr.active_mtu = mtu;
 	port->mtu_cap = ib_mtu_enum_to_int(mtu);
-
-	rxe_info_dev(rxe, "Set mtu to %d\n", port->mtu_cap);
 }
 
 /* called by ifc layer to create new rxe device.
-- 
2.29.2