Re: [RFC 3/9] PCI/portdrv: create platform devices for child OF nodes

From: Lukas Wunner
Date: Thu Jan 11 2024 - 10:02:30 EST


On Thu, Jan 11, 2024 at 05:09:09AM -0600, Bartosz Golaszewski wrote:
> On Thu, 11 Jan 2024 11:42:11 +0100, Lukas Wunner <lukas@xxxxxxxxx> said:
> > On Wed, Jan 10, 2024 at 02:18:30PM -0600, Bartosz Golaszewski wrote:
> >> On Wed, 10 Jan 2024 17:41:05 +0100, Lukas Wunner <lukas@xxxxxxxxx> said:
> >> > On Wed, Jan 10, 2024 at 05:26:52PM +0100, Bartosz Golaszewski wrote:
> >> > > Seems like the following must be true but isn't in my case (from
> >> > > pci_bus_add_device()):
> >> > >
> >> > > if (pci_is_bridge(dev))
> >> > > of_pci_make_dev_node(dev);
> >> > >
> >> > > Shouldn't it evaluate to true for ports?
> >> >
> >> > It should.
> >> >
> >> > What does "lspci -vvvvxxxx -s BB:DD.F" say for the port in question?
>
> # lspci -vvvvxxxx -s 0000:00:00
> 0000:00:00.0 PCI bridge: Qualcomm Technologies, Inc Device 010b
> (prog-if 00 [Normal decode])
> Device tree node: /sys/firmware/devicetree/base/soc@0/pcie@1c00000/pcie@0
[...]
> 00: cb 17 0b 01 07 05 10 00 00 00 04 06 00 00 01 00
^^
The Header Type in config space is 0x1, i.e. PCI_HEADER_TYPE_BRIDGE.

So pci_is_bridge(dev) does return true (unlike what you write above)
and control flow enters of_pci_make_dev_node().

But perhaps of_pci_make_dev_node() returns immediately because:

/*
* If there is already a device tree node linked to this device,
* return immediately.
*/
if (pci_device_to_OF_node(pdev))
return;

..and lspci does list a devicetree node for that Root Port.

In any case, of_pci_make_dev_node() is the right place to add
the call to of_platform_populate(). Just make sure it's called
even if there is already a DT node for the Root Port itself.

Thanks,

Lukas