Re: [PATCH v1 06/10] arm64: dts: rockchip: add USBDP phys on rk3588

[Johan Jonker]

On 2/12/24 19:48, Sebastian Reichel wrote:
> Hi Johan,
> 
> On Sun, Feb 11, 2024 at 08:24:36PM +0100, Johan Jonker wrote:
>>> +		u2phy1: usb2-phy@4000 {
>>
>>         "usb2phy@[0-9a-f]+$":
> 
> Interesting. I would have expected that to pop up in dtbs_check, but
> it does not for some reason. I will fix it for all usb2phy instances
> in rk3588.
> 
>>> +			compatible = "rockchip,rk3588-usb2phy";
>>> +			reg = <0x4000 0x10>;
>>> +			interrupts = <GIC_SPI 394 IRQ_TYPE_LEVEL_HIGH 0>;
>>
>>> +			resets = <&cru SRST_OTGPHY_U3_1>, <&cru SRST_P_USB2PHY_U3_1_GRF0>;
>>> +			reset-names = "phy", "apb";
>>> +			clocks = <&cru CLK_USB2PHY_HDPTXRXPHY_REF>;
>>> +			clock-names = "phyclk";
>>> +			clock-output-names = "usb480m_phy1";
>>> +			#clock-cells = <0>;
>>
>> Align with the (new) documentation
>> about property ordering.
>>
>>> +			status = "disabled";
>>> +
>>> +			u2phy1_otg: otg-port {
>>> +				#phy-cells = <0>;
>>> +				status = "disabled";
>>> +			};
>>> +		};
>>> +	};
> 
> The above follows everything from [0], which does not specify an
> order for the "standard/common  properties". For those this follows
> the order of existing usb2phy nodes. Did I miss any other new
> Documentation?
> 
> [0] https://www.kernel.org/doc/html/next/devicetree/bindings/dts-coding-style.html#order-of-properties-in-device-node

While reading the text below I think it's in need for a clarification that the property order for common and vendor category is alpha-numerical as is for nodes.
For Rockchip DT in this case "reset*" below "clock*", so that the person after you can add properties in a sort list.

Johan

===

The following order of properties in device nodes is preferred:

    "compatible"

    "reg"

    "ranges"

    Standard/common properties (defined by common bindings, e.g. without vendor-prefixes)

    Vendor-specific properties

    "status" (if applicable)

    Child nodes, where each node is preceded with a blank line

The "status" property is by default "okay", thus it can be omitted.


> 
> -- Sebastian