Re: [PATCH 0/5] Add QPIC SPI NAND driver

[Md Sadre Alam]

On 2/20/2024 5:06 PM, Krzysztof Kozlowski wrote:
> On 20/02/2024 12:32, Md Sadre Alam wrote:
> > On 2/19/2024 6:34 PM, Manivannan Sadhasivam wrote:
> > > On Thu, Feb 15, 2024 at 07:18:51PM +0530, Md Sadre Alam wrote:
> > > > This series of patches will add initial supports
> > > > for QPIC SPI NAND driver.
> > > >
> > > > Currently this driver support following commands
> > > >
> > > > -- RESET
> > > > -- READ ID
> > > > -- BLOCK ERASE
> > > > -- PAGE READ
> > > > -- PAGE WRITE
> > > > -- GET FEATURE
> > > > -- SET FEATURE
> > > > -- BAD BLOCK CHECK
> > > >
> > > > This driver has been tested with dd command with read/write page
> > > > with multiple file size 1MiB, 10MiB,40MiB etc.
> > > > Also tested with "mtd" command like mtd erase, mtd write, mtd verify etc.
> > >
> > > This is not the first version isn't it? Where is the changelog describing what
> > > has changed since then?
> >
> >     The earlier patch was the RFC for design review only.
>
> RFC is state of patch, not version. This is v2 then.
>
> These RFC postings are really becoming mess. Some people make multiple
> RFCs and then post v1 hiding entire previous history... And why even
> bother with calling it RFC?

 Sorry, I was not aware of this. Shall I post the next one as V3
 and add references to the RFC patch and this patch in the cover
 letter of V3?
> Best regards,
> Krzysztof