Re: [PATCH net-next 2/3] net: phy: dp83826: Add support for phy-mode configuration

[Andrew Lunn]

On Thu, Feb 22, 2024 at 11:31:16AM +0100, Jérémie Dautheribes wrote:
> The TI DP83826 PHY can operate in either MII mode or RMII mode.
> By default, it is configured by straps.
> It can also be configured by writing to the bit 5 of register 0x17 - RMII
> and Status Register (RCSR).
> 
> When phydev->interface is rmii, rmii mode must be enabled, otherwise
> mii mode must be set.
> This prevents misconfiguration of hw straps.
> 
> Signed-off-by: Jérémie Dautheribes <jeremie.dautheribes@xxxxxxxxxxx>
> ---
>  drivers/net/phy/dp83822.c | 11 +++++++++++
>  1 file changed, 11 insertions(+)
> 
> diff --git a/drivers/net/phy/dp83822.c b/drivers/net/phy/dp83822.c
> index 30f2616ab1c2..2d8275e59dcc 100644
> --- a/drivers/net/phy/dp83822.c
> +++ b/drivers/net/phy/dp83822.c
> @@ -100,6 +100,7 @@
>  #define DP83822_WOL_CLR_INDICATION BIT(11)
>  
>  /* RCSR bits */
> +#define DP83822_RMII_MODE_EN	BIT(5)
>  #define DP83822_RGMII_MODE_EN	BIT(9)
>  #define DP83822_RX_CLK_SHIFT	BIT(12)
>  #define DP83822_TX_CLK_SHIFT	BIT(11)
> @@ -500,6 +501,16 @@ static int dp83826_config_init(struct phy_device *phydev)
>  	u16 val, mask;
>  	int ret;
>  
> +	if (phydev->interface == PHY_INTERFACE_MODE_RMII)
> +		ret = phy_set_bits_mmd(phydev, DP83822_DEVADDR, MII_DP83822_RCSR,
> +				       DP83822_RMII_MODE_EN);
> +	else
> +		ret = phy_clear_bits_mmd(phydev, DP83822_DEVADDR, MII_DP83822_RCSR,
> +					 DP83822_RMII_MODE_EN);

I would probably add a test for MII and return -EINVAL if asked to do
something else altogether.

	  Andrew